Abstract:A radio frequency (RF) pulse compressor had been designed for the X-band (11.424 GHz) high power test stands at the Accelerator Laboratory of Tsinghua University. It is a SLED-I type pulse compressor, which uses a high quality factor corrugated circular cavity to store the RF power. An RF polarizer couples two quadrature modes into the cavity so that the pulse compressor needs only one cavity. The cavity implements HE1-1-14 mode, with the Q0 of 115,000 and the coupling factor ( ) of 3.23. The design and the microwave measurement before brazing of this pulse compressor are presented in this paper. INTRODUCTION RF pulse compressors enhance the RF peak power at the expense of shortening pulse widths. Passive pulse compressors, rather than active ones, have been widely used due to better stability and easier fabrication. The SLAC energy doubler (SLED-I), the resonant delay line pulse compressor (SLED-II) and the barrel open cavity (BOC) have been proposed and developed as three main types of passive pulse compression systems with different RF components. The SLED-I and SLED-II store the RF pulse in a resonant cavity or a delay line and output a decaying exponential or a flat pulse respectively, while the BOC type houses a whispering galley mode of high unloaded quality factor (Q0) in a more complicated cavity structure [1-3]. Typical pulse compression systems consist of two identical cavities or delay lines and a 3-dB coupler for isolation. A compact RF pulse compression system with one spherical cavity and an RF polarizer has been designed and tested at SLAC [4]. At Tsinghua University, the Tsinghua Thomson-scattering X-ray Source (TTX) upgrade project plans to add two X-band linacs in the injector and boost the electron beam from the current 50 MeV to 150 MeV, as shown in Fig. 1. To feed these two structures, a SLED-I type pulse compressor is required to compress the pulse width from 1.5 μs to 100 ns and generate more than 250 MW peak power from a 50 MW klystron at the frequency of 11.424 GHz.

X -Band Two-Stage Rf Pulse Compression System with Correction Cavity Chain

Design and Measurement of the X-Band Pulse Compressor for TTX

Rf Design of a Pulse Compressor with Correction Cavity Chain for Klystron-Based Compact Linear Collider

The X-Band Pulse Compressor for Tsinghua Thomson Scattering X-Ray Source

Development of a S-Band Pulse Compressor

The RF Design of a Compact, High Power Pulse Compressor with a Flat Output Pulse

Development of an S-band spherical pulse compressor

A Compact X-Band Microwave Pulse Compressor Using a Corrugated Cylindrical Cavity

Demonstration of a Cavity-Based Pulse Compression System for Pulse Shape Correction

Development of Tsinghua X-Band High Power Test Facility

Design and experiment of microwave pulse compressor with adjustable coupling coefficient

Development of an L-band Continuous-Wave Buncher at Tsinghua University

High Power Microwave System Based on Power Combination and Pulse Compression of Conventional Klystrons

High power microwave system based on power combining and pulse compression of conventional klystrons

Multi-stage Pulse Compression by Use of Cascaded Quadratic Nonlinearity

Fabrication and high-power testing of an X-band high-power phase shifter for the very compact inverse Compton scattering gamma-ray source

Coherent Combination of Power in Space With Two X-Band Gigawatt Coaxial Multi-Beam Relativistic Klystron Amplifiers

Pulse Duration Compression by Two-Stage Stimulated Brillouin Scattering and Stimulated Raman Scattering

The Design and Performance of an X-band Broadband Klystron With Peak Power of 1MW

Sub-two-cycle intense pulse generation based on two-stage hollow-core fiber compression using an ytterbium amplifier

Multi-stage bunch compression at the Japanese X-ray free electron laser SACLA