Abstract:A radio frequency (RF) pulse compressor had been designed for the X-band (11.424 GHz) high power test stands at the Accelerator Laboratory of Tsinghua University. It is a SLED-I type pulse compressor, which uses a high quality factor corrugated circular cavity to store the RF power. An RF polarizer couples two quadrature modes into the cavity so that the pulse compressor needs only one cavity. The cavity implements HE1-1-14 mode, with the Q0 of 115,000 and the coupling factor ( ) of 3.23. The design and the microwave measurement before brazing of this pulse compressor are presented in this paper. INTRODUCTION RF pulse compressors enhance the RF peak power at the expense of shortening pulse widths. Passive pulse compressors, rather than active ones, have been widely used due to better stability and easier fabrication. The SLAC energy doubler (SLED-I), the resonant delay line pulse compressor (SLED-II) and the barrel open cavity (BOC) have been proposed and developed as three main types of passive pulse compression systems with different RF components. The SLED-I and SLED-II store the RF pulse in a resonant cavity or a delay line and output a decaying exponential or a flat pulse respectively, while the BOC type houses a whispering galley mode of high unloaded quality factor (Q0) in a more complicated cavity structure [1-3]. Typical pulse compression systems consist of two identical cavities or delay lines and a 3-dB coupler for isolation. A compact RF pulse compression system with one spherical cavity and an RF polarizer has been designed and tested at SLAC [4]. At Tsinghua University, the Tsinghua Thomson-scattering X-ray Source (TTX) upgrade project plans to add two X-band linacs in the injector and boost the electron beam from the current 50 MeV to 150 MeV, as shown in Fig. 1. To feed these two structures, a SLED-I type pulse compressor is required to compress the pulse width from 1.5 μs to 100 ns and generate more than 250 MW peak power from a 50 MW klystron at the frequency of 11.424 GHz.

The RF Design of a Compact, High Power Pulse Compressor with a Flat Output Pulse

Rf Design of a Pulse Compressor with Correction Cavity Chain for Klystron-Based Compact Linear Collider

Design and Measurement of the X-Band Pulse Compressor for TTX

Development of an S-band spherical pulse compressor

Design of Compact Transmission Line Transformer for High Voltage Nanosecond Pulses

Development of a S-Band Pulse Compressor

The X-Band Pulse Compressor for Tsinghua Thomson Scattering X-Ray Source

X -Band Two-Stage Rf Pulse Compression System with Correction Cavity Chain

A Compact X-Band Microwave Pulse Compressor Using a Corrugated Cylindrical Cavity

Compact compressor based on unparallel gratings

Design of a Pulse Transformer for X-band Klystron

RF power system for compact pulsed hadron source

High Power Microwave System Based on Power Combination and Pulse Compression of Conventional Klystrons

High power microwave system based on power combining and pulse compression of conventional klystrons

A Compact High-Power Ultra-Wideband Bipolar Pulse Generator

Development of Tsinghua X-Band High Power Test Facility

Design of RF Power System for CPHS

A Long Pulse Relativistic Klystron Amplifier Driven by Low RF Power

An efficient high-power femtosecond laser based on periodic-layered-Kerr media nonlinear compression and a Yb:YAG regenerative amplifier

Design of A Source to Supply Ultra-Fast Electron and X-Ray Pulses

Design of a Compact Short Pulse Positron Source Based on Laser Plasma Accelerators