Abstract:Summary form only given. The mechanism of plasma formation under high power pulse (HPM) excitation in gases (nitrogen and argon) at atmospheric pressures is studied utilizing a fluid model verified against experimental data. A 2-D approximation was introduced to model the cylindrically shaped gas volume and the associated electric fields. Thus, the fluid equations and Poisson equation for space charge effects are updated in x and y directions only (setting the gradient in the z-direction to 0). The goal of this numerical simulation was to accurately predict the plasma formation delay time under different gas types and pressures based on the calculated evolution of the plasma conductivity.An S-band TE111 resonator with a built-in quartz gas isolation tube in the center was fabricated1. A 4 MW, 4 μs pulse in the dominant TE10 mode provided by a 2.85 GHz magnetron propagates through it. In the fluid model, the effect of HPM on plasma formation is modelled with particle heating as well as elastic and inelastic collisions driven by the incident electric field in the vertical (normal) coordinate. The amplitude distribution of the HPM electric field is obtained from numerical simulation of the resonator using commercial EM software. Since the focus is on the onset of plasma formation, simulation is stopped before a large plasma density develops up to the moment when the transmitted power is reduced by 10% (-0.5 dB), which corresponds to an average plasma conductivity of 0.02 S/m. Both measurement and simulation cover a gas pressure range from 25 to 700 torr with delay times for N <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> and Ar from 22 to 204 nanoseconds. The development of the particle densities and temperatures during the simulation is presented to reveal the dominant mechanism of plasma formation in atmospheric gases. The delay times for different gas types and pressures are in good agreement for low gas pressures (<; 200 torr). Deviations between the model and experiments at higher pressure are found to be primarily due to the onset of plasma filamentation.

Similarity Study of Low-Pressure Microwave Argon Plasma Based on Numerical Simulation

Numerical Studies of High Power Microwave Argon breakdown based on SETD method

Gas Heating Analysis in High-Power Microwave Breakdown Process Based on SETD Method

Simulation of Microwave Breakdown Electric Field in Air

The Simulation for Microwave Plasma Breakdown Process

Transient Analysis of High-Power Microwave Air Breakdown under External DC Magnetic Field

Numerical Studies of Light Brightness Emitted by Microwave Nitrogen Breakdown in Circular Waveguide

Calculation of Microwave Breakdown Electric Field Using the Equivalent Characteristic Diffusion Length

Transient Analysis of Light Brightness Emitted from High Power Microwave Nitrogen Breakdown under External Dc Magnetic Field

Monte Carlo Simulation of Microwave Air Breakdown in Parallel Plates Considering Electron-Surface Interaction

Numerical Simulation of Outgassing in the Breakdown on Dielectric Surface Irradiated by High Power Microwave

Study on Atmospheric Breakdown Experimental for Single Hpm Pulse

A Simplified 2-D Fluid Model Of Plasma Formation Under Pulsed High Power Microwaves In Atmospheric Gases

The Relation Between the High-frequency Gas Breakdown and the Vacuum Breakdown

Numerical Simulations of High Power Microwave Dielectric Interface Breakdown Involving Outgassing

Electrical Breakdown Simulation for Microwave Power Amplifier

Improved Model for Window Breakdown at Low Pressure

Simulation Analysis of High Power Microwave Propagation Properties in a Simplified Plasma Limiter

Simulation on Breakdowns in the Post-Arc Phase of a Vacuum Interruption

Simulations of Breakdown Voltage of Coplanar Electrodes Microplasma Devices

Establishing an equivalent circuit for a quasihomogeneous discharge atmospheric-pressure plasma jet with a breakdown-voltage-controlled breaker and power supply circuit