Abstract:Abstract The gas desorbed from the dielectric surface has a great influence on the characteristics of microwave breakdown on the vacuum side of the dielectric window. In this paper, the dielectric surface breakdown is described by using the electromagnetic particle-in-cell-Monte Carlo collision (PIC-MCC) model. The process of desorption of gas and its influence on the breakdown characteristics are studied. The simulation results show that, due to the accumulation of desorbed gas, the pressure near the dielectric surface increases in time, and the breakdown mechanism transitions from secondary electron multipactor to collision ionization. More and more electrons generated by collision ionization drift to the dielectric surface, so that the amplitude of self-organized normal electric field increases in time and sometimes points to the dielectric surface. Nevertheless, the number of secondary electrons emitted in each microwave cycle is approximately equal to the number of primary electrons. In the early and middle stages of breakdown, the attenuation of the microwave electric field near the dielectric surface is very small. However, the collision ionization causes a sharp increase in the number density of electrons, and the microwave electric field decays rapidly in the later stage of breakdown. Compared with the electromagnetic PIC-MCC simulation results, the mean energy and number of electrons obtained by the electrostatic PIC-MCC model are overestimated in the later stage of breakdown because it does not take into account the attenuation of microwave electric field. The pressure of the desorbed gas predicted by the electromagnetic PIC-MCC model is close to the measured value, when the number of gas atoms desorbed by an incident electron is taken as 0.4.

Gas Heating Analysis in High-Power Microwave Breakdown Process Based on SETD Method

Numerical Studies of High Power Microwave Argon breakdown based on SETD method

Transient simulation of dielectric breakdown during high-power microwave propagation based on the SETD method

Transient Analysis of High-Power Microwave Air Breakdown under External DC Magnetic Field

Similarity Study of Low-Pressure Microwave Argon Plasma Based on Numerical Simulation

Numerical Studies of Dielectric Breakdown during High-Power Operation Based on SETD Method

Experimental Investigation and Analysis of the LDMOS FET Breakdown Under HPM Pulses

Numerical Studies of Light Brightness Emitted by Microwave Nitrogen Breakdown in Circular Waveguide

Transient Analysis of Light Brightness Emitted from High Power Microwave Nitrogen Breakdown under External Dc Magnetic Field

Numerical Simulation of Multi-Carrier Microwave Breakdown in Air-Sf6 Mixtures

Experimental Study on Breakdown Characteristics of Microwave Gas Discharge Tubes

Gas breakdown driven by L band short-pulse high-power microwave

A new approach for dielectric breakdown calculation of residual hot gas after arc burning based on particle transport and Boltzmann analysis

Experiments on Helium Breakdown at High Pressure and Temperature in Uniform Field and Its Simulation Using COMSOL Multiphysics and FD-FCT

Simulation Analysis of High Power Microwave Propagation Properties in a Simplified Plasma Limiter

Numerical simulation of waveguide plasma limiter under high power microwave based on the SETD method

Effect of desorbed gas on microwave breakdown on vacuum side of dielectric window

Study on Breakdown Characteristics and Attenuation Characteristics of Air Mixed Gas

Experiments and Simulation of Helium Breakdown at High Pressure and Temperature in a Non-Uniform Electric Field

Priliminary Modeling of Air Breakdown with the ICEPIC code

Kinetic analysis of direct-current driven microdischarges with thermo-field electron emission at atmospheric pressure