Abstract:This study investigates friction and film thickness in elastohydrodynamic contacts of machined, rough surfaces, where roughness is dominated by longitudinal ridges parallel to the rolling/sliding direction. A ball-on-disc tribometer was used to simultaneously measure friction and film thickness in rough contacts as well as with nominally smooth specimens for comparison. The studied rough surfaces were selected so that the influence of the root-mean-square roughness and roughness wavelength can be assessed. Friction and film measurements were taken over a range of slide–roll ratios and speeds and with two lubricating oils with different viscosities, hence covering a wide range of specific film thicknesses. The measurements with the nominally smooth specimens show that friction is strongly influenced by thermal effects at high SRRs and that the transition from mixed/boundary to full EHD lubrication occurs at lambda ratios greater than three. At low speeds, the rough specimens are found to generate higher friction than the smooth ones for all the roughness structures considered, and this is shown to be related to the thinner minimum film thickness. Comparison of friction in rough and smooth contacts shows that the total friction in rough contacts can be divided into two components: one that is equivalent to friction in smooth contacts under the same conditions and is dependent on the slide–roll ratio, and the other that is due to the presence of roughness and is independent of the slide–roll ratio under the conditions tested. Further analysis of the minimum film thickness on tops of roughness ridges indicates that even after the full lift-off, an effect of the roughness on friction persists and is most likely related to the local shear stress in the micro-EHD contacts on the top of roughness ridges. At even higher speeds, the difference in friction between the rough and smooth specimens vanishes.

Effect of Height Waviness on the Friction Behavior of 100cr6 Steel under Mixed or Hydrodynamic Lubrication

Waviness Affects Friction and Abrasive Wear

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Frictional Characteristic Curves of Ground Surfaces in Lubricated Sliding

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Effect of Wear-Induced Surface Deformation on Stick-Slip Friction of Galvanized Automotive Steels

Influence of the Machining Process on the Wear Properties of Self-Mated Structural Steel in Dry Sliding Conditions

Influence of Counter Surface Roughness and Lay on the Tribological Behaviour of Self-Lubricating Bearing Materials in Dry Sliding Conditions at High Contact Pressures

Influence of Groove Surface Texture on Temperature Rise under Dry Sliding Friction

The Relationship Between Friction and Film Thickness in EHD Point Contacts in the Presence of Longitudinal Roughness

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Influence of displacement amplitude on fretting-induced friction and wear of steel in oil-lubricated contact

EFFECTS OF SURFACE PREPARATION ON FRICTION AND WEAR IN DRY SLIDING CONDITIONS

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Tribological mechanisms of slurry abrasive wear

Friction Performance of Wc-Co Coating with Lithium Grease and Water Lubrication

The effect of groove-textured surface on friction and wear and friction-induced vibration and noise

Study on the wear performance of 304 stainless steel aerospace joint bearings