Abstract:This paper presents a WR-2.2 band (330-500 GHz) waveguide with E-plane bends and a waveguide bandpass filter. A micro-metal additive manufacturing technology employs copper to process these devices. This technology includes several micromachining processes, which can produce integrated, miniaturized, and complex three-dimensional metal microstructures when meeting the process constraints. To successfully apply this technology to the fabrication of terahertz waveguide devices, many design details are considered. First, the E-plane bent transition structures in the waveguide overcome size limitations imposed by the manufacturing process, allowing for accurate measurement using standard waveguide interfaces. Second, the rectangular resonators compose the fifth-order waveguide bandpass filter spanning 20 GHz with a center frequency of 380 GHz. Given that the excess photoresist needs to be removed, some release holes are designed in the proper positions of the filter. Third, to increase the uniformity of the device layout and improve the machining quality in the electroforming process, a lot of rectangular holes are arranged around the device. By adopting a meticulous and novel design method in accordance with the process advantages and limitations, the fabrication accuracy of the device size is greatly increased. The integrated filter with exceptional performance is obtained. The measured average insertion loss within the passband is better than 1.2 dB, and the return loss exceeds 15 dB. Additionally, the filter demonstrates a center frequency offset of approximately 0.5%. Good consistency between simulation and measurement shows the validity of design and fabrication.

An $H$-Plane High-Flatness Ridge Waveguide Dual-Directional Coupler Based on Copper Additive Manufacturing

A 110-260Ghz Dual-Directional Coupler Based on Copper Additive Manufacturing

A 0.22–26.5-Ghz Ultra-Wideband Directional Coupler Based on Copper Additive Manufacturing

A D-Band Waveguide Diplexer Based on Copper Additive Manufacturing

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

WR-3.4 Band Waveguide and Bandpass Filters Using Copper Additive Manufacturing

Asymmetric Plasmonic-Dielectric Coupler with Short Coupling Length, High Extinction Ratio, and Low Insertion Loss.

A New Plasmonic Coupler for MDM Waveguide Based on the Metallic Voids

Structurally-tolerant Vertical Directional Coupling Between Metal-Insulator-metal Plasmonic Waveguide and Silicon Dielectric Waveguide

A 0.38–67-Ghz Directional Coupler with GSG Interface for Compact VNA System

A Novel E-plane Half-Mode Substrate Integrated Waveguide (HMSIW) Coupler

Compact and efficient coupler to interface hybrid dielectric-loaded plasmonic waveguide with silicon photonic slab waveguide

A Novel Multilayer E-Plane Half-Mode Substrate Integrated Waveguide (hmsiw) 3-Db Coupler with Improved Out-Of-Band Rejection

D-band Waveguide Diplexer Fabricated Using Micro Laser Sintering

Micro Metal Additive Manufactured Low-Loss Slotted Rectangular Waveguides Operating at 220-500 GHz

An additively manufactured dual circularly polarized open‐ended waveguide antenna using outer ridges with wideband characteristic

A W-Band Low-Loss Planar MMICs to RWG Transition Using Copper Additive Manufacturing and Its 1-D Phased Array Antenna-in-Package Application

Copper Micromachined WR‐2.2 Band Waveguide and Bandpass Filter

A Slow Wave Folded Ridge HMSIW Using Spoof Surface Plasmon Polaritons Structure and Its Application in Coupler Design

Ka-Band Monolithic Stereolithography 3-D Printed Broadband Passive Waveguide Devices