Abstract:Liquid atomization is applied in nanostructure dense coating technology to inject suspended nano-size powder materials into a suspension plasma spray (SPS) torch. This paper presents the effects of the atomization parameters on the nanoparticle processing. A numerical model was developed to simulate the dynamic behaviors of the suspension droplets, the solid nanoparticles or agglomerates, as well as the interactions between them and the plasma gas. The plasma gas was calculated as compressible, multi-component, turbulent jet flow in Eulerian scheme. The droplets and the solid particles were calculated as discrete Lagrangian entities, being tracked through the spray process. The motion and thermal histories of the particles were given in this paper and their release and melting status were observed. The key parameters of atomization, including droplet size, injection angle and velocity were also analyzed. The study revealed that the nanoparticle processing in SPS preferred small droplets with better atomization and less aggregation from suspension preparation. The injection angle and velocity influenced the nanoparticle release percentage. Small angle and low initial velocity might have more nanoparticles released. Besides, the melting percentage of nanoparticles and agglomerates were studied, and the critical droplet diameter to ensure solid melting was drawn. Results showed that most released nanoparticles were well melted, but the agglomerates might be totally melted, partially melted, or even not melted at all, mainly depending on the agglomerate size. For better coating quality, the suspension droplet size should be limited to a critical droplet diameter, which was inversely proportional to the cubic root of weight content, for given critical agglomerate diameter of being totally melted.

Production of Ultrafine Particles with Nanometer Size Distribution Via a Bubble Film Bursting Method

Effect of Ultrasonic Intensification on Synthesis of Nano-Sized Particles with an Impinging Jet Reactor

Generating Ultra-Small Droplets Based on a Double-Orifice Technique

Complete Breakup of Liquids into Ultrafine Droplets by Grid Turbulence

Generation of Ultrafine Droplets in Femtoliter Scale from a Large Needle with Diameter of 200 Microns

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Generating nano/microliter droplets with on-demand repetition rates by femtosecond filament-fabricated superhydrophobic bevel needle nozzles

Preparation of Nano‐pico Droplets Using an Open Fibrous System

Synthesis of Scalable Micro-Droplets with Heat-Driven Effect in Flow-Focusing Device.

Accurate Generation of Attolitre Droplets for Directly Printing Gold Nanoparticles from Solution Through Confined Reaction

Generation of monodispersed microdroplets by temperature controlled bubble condensation processes.

High Yielding Microbubble Production Method

Micro Bubble Generation with Pressurized Droplet from Ultra Fine Bubble Water and Its Cleaning Effect

Micro-sized droplet formation by interaction between dielectric barrier discharge and liquid

Simple Method to Generate Droplets Spontaneously by a Superhydrophobic Double-Layer Split Nozzle.

Water-to-air transfer of nano/micro-sized particulates: enrichment effect in bubble bursting jet drops

Novel Microfabricated Nozzle Array with Grooves for Microdroplet Generation

Effects of bubbles in the liquid jet on the air-blast atomization

Modelling Of Uniform Micron-Sized Metal Particles Production Using Harmonic Mechanical Excitation

Nanoemulsions obtained via bubble bursting at a compound interface

Manipulation of Nanodroplets Via a Nonuniform Focused Acoustic Vortex