Abstract:This paper presents an electrohydrodynamic emulsification scheme that is capable of producing sub-femtoliter aqueous droplets on demand. A pressure-controlled flow focusing scheme is enhanced by integrating a time-varying electric field, which induces electric forces locally on the water-oil interface. More specifically, electric forces act against interfacial tension and trigger the breakup of droplets via tip streaming. PDMS microfluidic chips with embedded solid electrodes and diaphragm valves are utilized to realize the proposed on-demand droplet formation scheme. In the prototype demonstration, a low melting-point alloy mixed with magnetic nanoparticles was inductively heated and injected into microchannels to form solid electrodes. It is demonstrated that the emulsification process is controlled by the applied fluid pressures and electric field, but not limited by the minimum width of flow channel. Extremely small droplets with volumes less than 1 femtoliter can be readily produced. By applying a voltage ramp of 8 kV/s (0-400V in 50 ms) across a distance of 6 mm, droplets with diameters less than 1 pin were successfully produced. The higher the voltage ramp rate, the smaller the resulting droplet volume. By adjusting the voltage ramp rate accordingly, on-demand formation of a droplet stream with preset diameter order was demonstrated. As such, the demonstrated emulsification scheme could potentially realize the controllability of electric field on the on-demand formation of extremely-small droplets, which is desired for a variety of applications. (C) 2018 Elsevier B.V. All rights reserved.

Generation of Ultrafine Droplets in Femtoliter Scale from a Large Needle with Diameter of 200 Microns

Scalable Droplet Generator Design Using Parallel-Arranged Capillaries with Axial Misalignment

Controlled Production of Emulsion Drops Using an Electric Field in a Flow-Focusing Microfluidic Device

Generating Ultra-Small Droplets Based on a Double-Orifice Technique

Fine Droplet Generation Using Tunable Electrohydrodynamic Pulsation

Electric Field-Assisted Droplet Formation Using Piezoactuation-Based Drop-On-Demand Inkjet Printing

Generating nano/microliter droplets with on-demand repetition rates by femtosecond filament-fabricated superhydrophobic bevel needle nozzles

Generation of Micro-Droplet on Demand with Reduced Sizes by a Hybrid Pneumatic Electrohydrodynamic Method

Production of Ultrafine Particles with Nanometer Size Distribution Via a Bubble Film Bursting Method

Accurate Generation of Attolitre Droplets for Directly Printing Gold Nanoparticles from Solution Through Confined Reaction

Electric-field Triggered, On-Demand Formation of Sub-Femtoliter Droplets

Preparation of Nano‐pico Droplets Using an Open Fibrous System

Electrohydrodynamic deposition of polymeric droplets under low-frequency pulsation.

Electric Field Assisted Manipulation of Microdroplets on a Superhydrophobic Surface.

Simulation and Experiment on Droplet Formation and Separation for Needle-Type Micro-Liquid Jetting Dispenser

A novel generator for the preparation of monodisperse femtoliter droplets at high frequency

Janus Droplets And Droplets With Multiple Heterogeneous Surface Strips Generated With Nanoparticles Under Applied Electric Field

Simple Method to Generate Droplets Spontaneously by a Superhydrophobic Double-Layer Split Nozzle.

Simulation and Printing of Microdroplets Using Straight Electrode-Based Electrohydrodynamic Jet for Flexible Substrate

Generation of Sub-Femtoliter Droplet by T-Junction Splitting on Microfluidic Chips

Facile and scalable generation of fluorescent microspheres using a microfluidic electrojetting device