Abstract:Due to the growing use of composite materials in aircraft structures, Aircraft Smart Composite Skins (ASCSs) which have the capability of impact monitoring for large-scale composite structures need to be developed. However, the impact of an aircraft composite structure is a random transient event that needs to be monitored on-line continuously. Therefore, the sensor network of an ASCS and the corresponding impact monitoring system which needs to be installed on the aircraft as an on-board device must meet the requirements of light weight, low power consumption and high reliability. To achieve this point, an Impact Region Monitor (IRM) based on piezoelectric sensors and guided wave has been proposed and developed. It converts the impact response signals output from piezoelectric sensors into Characteristic Digital Sequences (CDSs), and then uses a simple but efficient impact region localization algorithm to achieve impact monitoring with light weight and low power consumption. However, due to the large number of sensors of ASCS, the realization of lightweight sensor network is still a key problem to realize an applicable ASCS for on-line and continuous impact monitoring. In this paper, three kinds of lightweight piezoelectric sensor networks including continuous series sensor network, continuous parallel sensor network and continuous heterogeneous sensor network are proposed. They can greatly reduce the lead wires of the piezoelectric sensors of ASCS and they can also greatly reduce the monitoring channels of the IRM. Furthermore, the impact region localization methods, which are based on the CDSs and the lightweight sensor networks, are proposed as well so that the lightweight sensor networks can be applied to on-line and continuous impact monitoring of ASCS with a large number of piezoelectric sensors. The lightweight piezoelectric sensor networks and the corresponding impact region localization methods are validated on the composite wing box of an unmanned aerial vehicle. The accuracy rate of impact region localization is higher than 92%.

Structural Health Monitoring of an Aircraft Wing Using a Portable Wireless Electro-Mechanical Impedance Analyzer

Active health monitoring of an aircraft wing with an embedded piezoelectric sensor/actuator network: II. Wireless approaches

Toward On-Orbit Structural Health Monitoring of Inflatablestructures Using Electromechanical Impedance Method

Piezoelectric Transducer-Based Structural Health Monitoring for Aircraft Applications

Active health monitoring of an aircraft wing with embedded piezoelectric sensor/actuator network: I. Defect detection, localization and growth monitoring

System-on-Chip Integration of a New Electromechanical Impedance Calculation Method for Aircraft Structure Health Monitoring

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

New Sensor Technologies in Aircraft Structural Health Monitoring

Structural Health Monitoring Cost Estimation of a Piezosensorized Aircraft Fuselage

Wireless Structural Health Monitoring and Early-Stage Damage Detection Using Piezoelectric Impedance Sensors

Industrial application of a low-cost structural health monitoring system in large-scale airframe tests

An Advanced Multi-Sensor Acousto-Ultrasonic Structural Health Monitoring System: Development and Aerospace Demonstration

A Miniaturized and Ultra-Low-Power Wireless Multi-Parameter Monitoring System with Self-Powered Ability for Aircraft Smart Skin

A Flexible and Lightweight Impact Monitoring System with Ultra-low Power Consumption for Aircraft Smart Composite Skin

Study on New Structural Health Monitoring Sensor of Aircraft

A piezoelectric sensor network with shared signal transmission wires for structural health monitoring of aircraft smart skin

Airplane hot spot monitoring using integrated impedance and guided wave measurements

Integrated Structural Health Monitoring System for Civil Aircraft Structures

Health Monitoring of Metallic Structures with Electromechanical Impedance and Piezoelectric Sensors

Impact Monitoring for Aircraft Smart Composite Skins Based on a Lightweight Sensor Network and Characteristic Digital Sequences

A structural health monitoring project for a composite unmanned aerial vehicle wing: overview and evaluation tests