Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Study on New Structural Health Monitoring Sensor of Aircraft

Piezoelectric Sensing Techniques in Structural Health Monitoring: A State-of-the-Art Review

Piezoelectric Transducer-Based Structural Health Monitoring for Aircraft Applications

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Study on Structure health monitoring method of space vehicle based on PVDF piezoelectric film

Review on Structural Health Monitoring in Metal Aviation Based on Fiber Bragg Grating Sensing Technology

Active health monitoring of an aircraft wing with embedded piezoelectric sensor/actuator network: I. Defect detection, localization and growth monitoring

A piezoelectric sensor network with shared signal transmission wires for structural health monitoring of aircraft smart skin

Damage monitoring of aircraft structural components based on large-area flexible graphene strain sensors

Advanced Sensors and Sensing Systems for Structural Health Monitoring in Aerospace Composites

Integration Technology with Thin Films Co-Fabricated in Laminated Composite Structures for Defect Detection and Damage Monitoring

Structural Health Monitoring System Based on a Concept of Lamb Wave Focusing by the Piezoelectric Array

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

Piezoelectric Materials and Sensors for Structural Health Monitoring: Fundamental Aspects, Current Status, and Future Perspectives

Ultrasonic Guided Wave Health Monitoring of High-Temperature Aircraft Structures Based on Variational Mode Decomposition and Fuzzy Entropy

Towards a practical structural health monitoring technology for patched cracks in aircraft structure

Health monitoring of a composite wingbox structure

Flexible, monolithic piezoelectric sensors for large-area structural impact monitoring via MUSIC-assisted machine learning

Damage detection for structural health monitoring using ultra-sensitive flexible piezoelectret sensors

Active health monitoring of an aircraft wing with an embedded piezoelectric sensor/actuator network: II. Wireless approaches

Corrosion Monitoring Method of Porous Aluminum Alloy Plate Hole Edges Based on Piezoelectric Sensors