Abstract:This paper investigated the effect of sensor density and alignment for three-dimensional shape sensing of an airplane-wing-shaped thick panel subjected to three different loading conditions, i.e., bending, torsion, and membrane loads. For shape sensing analysis of the panel, the Inverse Finite Element Method (iFEM) was used together with the Refined Zigzag Theory (RZT), in order to enable accurate predictions for transverse deflection and through-the-thickness variation of interfacial displacements. In this study, the iFEM-RZT algorithm is implemented by utilizing a novel three-node C°-continuous inverse-shell element, known as i3-RZT. The discrete strain data is generated numerically through performing a high-fidelity finite element analysis on the wing-shaped panel. This numerical strain data represents experimental strain readings obtained from surface patched strain gauges or embedded fiber Bragg grating (FBG) sensors. Three different sensor placement configurations with varying density and alignment of strain data were examined and their corresponding displacement contours were compared with those of reference solutions. The results indicate that a sparse distribution of FBG sensors (uniaxial strain measurements), aligned in only the longitudinal direction, is sufficient for predicting accurate full-field membrane and bending responses (deformed shapes) of the panel, including a true zigzag representation of interfacial displacements. On the other hand, a sparse deployment of strain rosettes (triaxial strain measurements) is essentially enough to produce torsion shapes that are as accurate as those of predicted by a dense sensor placement configuration. Hence, the potential applicability and practical aspects of i3-RZT/iFEM methodology is proven for three-dimensional shape-sensing of future aerospace structures.

Airplane hot spot monitoring using integrated impedance and guided wave measurements

Active health monitoring of an aircraft wing with embedded piezoelectric sensor/actuator network: I. Defect detection, localization and growth monitoring

Ultrasonic Guided Wave Health Monitoring of High-Temperature Aircraft Structures Based on Variational Mode Decomposition and Fuzzy Entropy

Impedance based damage detection under varying temperature and loading conditions

Active health monitoring of an aircraft wing with an embedded piezoelectric sensor/actuator network: II. Wireless approaches

The temperature effects on embedded PZT signals in structural health monitoring for composite structures with different thicknesses

Integration Technology with Thin Films Co-Fabricated in Laminated Composite Structures for Defect Detection and Damage Monitoring

Health monitoring of a composite wingbox structure

Structural Integrity Assessment of Composites Plates with Embedded PZT Transducers for Structural Health Monitoring

Ultrasonic guided wave monitoring of composite wing skin-to-spar bonded joints in aerospace structures

Damage monitoring of aircraft structural components based on large-area flexible graphene strain sensors

Structural health monitoring of composite wing structure during durability test

System-on-Chip Integration of a New Electromechanical Impedance Calculation Method for Aircraft Structure Health Monitoring

A piezoelectric sensor network with shared signal transmission wires for structural health monitoring of aircraft smart skin

A high-performance, sensitive, low-cost LIG/PDMS strain sensor for impact damage monitoring and localization in composite structures

Axial stress monitoring strategy in arbitrary cross-section based on acoustoelastic guided waves using PZT sensors

Probability based damage detection on a composite fuselage panel based on large data set of guided wave signals

A structural health monitoring project for a composite unmanned aerial vehicle wing: overview and evaluation tests

An open database for benchmarking guided waves structural health monitoring algorithms on a composite full-scale outer wing demonstrator

Modeling of Sensor Placement Strategy for Shape Sensing and Structural Health Monitoring of a Wing-Shaped Sandwich Panel Using Inverse Finite Element Method

Integrated Structural Health Assessment Using Piezoelectric Active Sensors