Abstract:The detection of impact damage in fiber reinforced composites is of significant concern because such damage can reduce the load-bearing ability of the composite. A number of factors can influence the nature and extent of impact damage development in composites including: (1) the type of reinforcing fiber and resin system; (2) the magnitude of the residual (fabrication) stresses; (3) the lay-up sequence; and (4) other factors such as the nature of the impactor, impact velocity, impact energy, temperature, moisture content in the composites etc.. From a structural health monitoring point of view, it is necessary to investigate the distribution of damage through the thickness of the composite. This paper reports on a simple, partially multiplexed optical fiber strain sensor system for in-situ strain and residual strain measurements in a carbon fiber reinforced epoxy composite. An extrinsic Fabry-Perot interferometric (EFPI) sensor design was used along with single mode fibers. The multiplexing scheme was based on wavelength division via the use of two super luminescent diodes at different wavelengths. A low-cost fiber optic CCD spectrometer was used as the detector. The multiplexing scheme was demonstrated using two EFPI sensors. In principle, a number of EFPI sensors can be multiplexed using the proposed scheme provided that each sensor is illuminated at a specified and different wavelength. The feasibility of detecting the residual strain in the composite was demonstrated successfully at two specified positions within a 16-ply carbon fiber reinforced composite. Preliminary results indicated that the sensor system was also capable of detecting the effects of a 3.2 J impact. Excellent correlation was obtained between the EFPI sensor output and that obtained using surface mounted strain gauges.

A high-performance, sensitive, low-cost LIG/PDMS strain sensor for impact damage monitoring and localization in composite structures

Damage monitoring of aircraft structural components based on large-area flexible graphene strain sensors

Health Monitoring for Composite Materials with High Linear and Sensitivity GnPs/epoxy Flexible Strain Sensors

A Flexible and Multipurpose Piezoresistive Strain Sensor Based on Carbonized Phenol Formaldehyde Foam for Human Motion Monitoring

Flexible piezoelectric composite sensor for impact monitoring of curved structures

Three-dimensional surface strain sensor based on LIG/PDMS composite film with adjustable electromechanical performance

Laser induced graphene for in situ damage sensing in aramid fiber reinforced composites

Multifunctional Motion Sensing Enabled by Laser-Induced Graphene

Graphene Nanoplatelets/Polydimethylsiloxane Flexible Strain Sensor with Improved Sandwich Structure

Development of highly sensitive and stable patterned PDMS flexible strain sensors for motion monitoring via laser direct writing

Ultrathin, Graphene‐in‐Polyimide Strain Sensor Via Laser‐Induced Interfacial Ablation of Polyimide

Laser-induced Porous Graphene on Polyimide/PDMS Composites and Its Kirigami-Inspired Strain Sensor

Ultrasensitive MWCNT/PDMS Composite Strain Sensor Fabricated by Laser Ablation Process

Multifunctional strain sensor with adjustable conductive network for wearable applications

Damage detection of FRP structures using the electrical resistance response of MWCNTs networks in a PDMS film substrate

Laser-Induced Graphene Strain Sensors for Body Movement Monitoring

Flexible Wearable Strain Sensors Based on Laser-Induced Graphene for Monitoring Human Physiological Signals

High-performance strain sensors based on functionalized graphene nanoplates for damage monitoring

Stretchable, Highly Durable Ternary Nanocomposite Strain Sensor For Structural Health Monitoring Of Flexible Aircraft

Strain Sensing Behaviors of GnPs/epoxy Sensor and Health Monitoring for Composite Materials under Monotonic Tensile and Cyclic Deformation

A Multiplexed Extrinsic Fabry-Perot Sensor System for In-Situ Strain and Impact Damage Detection in Composites