Abstract:Soil and groundwater contamination caused by petroleum hydrocarbons is a severe environmental problem. In this study, a novel electrolyzed catalytic system (ECS) was developed to produce nanobubble-contained electrolyzed catalytic (NEC) water for the remediation of petroleum-hydrocarbon-contaminated soils and groundwater. The developed ECS applied high voltage (220 V) with direct current, and titanium electrodes coated with iridium dioxide were used in the system. The developed ECS prototype contained 21 electrode pairs (with a current density of 20 mA/cm 2 ), which were connected in series to significantly enhance the hydroxyl radical production rate. Iron-copper hybrid oxide catalysts were laid between each electrode pair to improve the radical generation efficiency. The electron paramagnetic resonance (EPR) and Rhodamine B (RhB) methods were applied for the generated radical species and concentration determination. During the operation of the ECS, high concentrations of nanobubbles (nanobubble density = 3.7 × 10 9 particles/mL) were produced due to the occurrence of the cavitation mechanism. Because of the negative zeta potential and nano-scale characteristics of nanobubbles (mean diameter = 28 nm), the repelling force would prevent the occurrence of bubble aggregations and extend their lifetime in NEC water. The radicals produced after the bursting of the nanobubbles would be beneficial for the increase of the radical concentration and subsequent petroleum hydrocarbon oxidation. The highly oxidized NEC water (oxidation-reduction potential = 887 mV) could be produced with a radical concentration of 9.5 × 10 −9 M. In the pilot-scale study, the prototype system was applied to clean up petroleum-hydrocarbon polluted soils at a diesel-oil spill site via an on-site slurry-phase soil washing process. The total petroleum hydrocarbon (TPH)-contaminated soils were excavated and treated with the NEC water in a slurry-phase reactor. Results show that up to 74.4% of TPH (initial concentration = 2846 mg/kg) could be removed from soils after four rounds of NEC water treatment (soil and NEC water ratio for each batch = 10 kg: 40 L and reaction time = 10 min). Within the petroleum-hydrocarbon plume, one remediation well (RW) and two monitor wells (located 1 m and 3 m downgradient of the RW) were installed along the groundwater flow direction. The produced NEC water was injected into the RW and the TPH concentrations in groundwater (initial concentrations = 12.3–15.2 mg/L) were assessed in these three wells. Compared to the control well, TPH concentrations in RW and MW1 dropped to below 0.4 and 2.1 mg/L after 6 m 3 of NEC water injection in RW, respectively. Results from the pilot-scale study indicate that the NEC water could effectively remediate TPH-contaminated soils and groundwater without secondary pollution production. The main treatment mechanisms included (1) in situ chemical oxidation via produced radicals, (2) desorption of petroleum hydrocarbons from soil particles due to the dispersion of nanobubbles into soil pores, and (3) enhanced TPH oxidation due to produced radicals and energy after nanobubble bursting.

Enhanced Migration and Degradation of Nitrobenzene in Heterogeneous Porous Media Using Pulsed Direct Current Electrical Resistance Heating with Hydraulic Circulation

Enhanced semi-volatile DNAPL accessibility at sub-boiling temperature during electrical resistance heating in heterogeneous porous media

Enhancing DNAPL removal from low permeability zone using electrical resistance heating with pulsed direct current

Electrical Stimulation Accelerated Phenanthrene Biodegradation Coupling with Nitrate Reduction in Groundwater

Application of Pd/C Catalyst to Degradation and Utilization of Nitrobenzene in Water

Factors affecting gas migration and contaminant redistribution in heterogeneous porous media subject to electrical resistance heating

Electrokinetic remediation of petroleum hydrocarbon contaminated soil (I)

Heat and mass transfer induced by alternating current during desorption of PAHs from soil using electrical resistance heating

Enhancing remediation of PAH-contaminated soil through coupling electrical resistance heating using Na2S2O8

Direct current driven persulfate delivery and activation for heterogeneous porous media remediation: Coupling effects of electric-thermal-chemical-flow fields

p-Nitrophenol contaminated soil remediation in a spray-type coaxial cylindrical dielectric barrier discharge plasma system

Remediation of polycyclic aromatic hydrocarbons (PAHs) contaminated soil with double dielectric barrier discharge plasma technology: Influencing parameters

Remediation Of Phenanthrene-Contaminated Soil Using Non-Thermal Plasma Fluidized Bed

Spatiotemporal dynamic temperature variation dominated by ion behaviors during groundwater remediation using direct current

Thermal Desorption for Remediating PCB-contaminated Soil

Electrokinetically-delivered persulfate coupled with thermal conductive heating for remediation of petroleum hydrocarbons contaminated low permeability soil

Remediation of Pyrene Contaminated Soil by Double Dielectric Barrier Discharge Plasma Technology: Performance Optimization and Evaluation.

Enhancing the microbial advanced oxidation of P-nitrophenol in sediment through accelerating extracellular respiration with electrical stimulation

High-temperature electrothermal remediation of multi-pollutants in soil

The use of 2D non-uniform electric field to enhance in situ bioremediation of 2,4-dichlorophenol-contaminated soil.

Application of novel nanobubble-contained electrolyzed catalytic water to cleanup petroleum-hydrocarbon contaminated soils and groundwater: A pilot-scale and performance evaluation study