Abstract:Purpose The purpose of this paper is to develop thermal modelling to investigate the thermal response of sample boards (at board level) during the preheating stage of the reflow process and to validate with experimental measurements. Design/methodology/approach A thermal‐coupling method that adopted the Multi‐physics Code Coupling Interface (MpCCI) was utilized. A forced‐convection reflow oven was modelled using computational fluid dynamic software ( FLUENT 6.3.26 ), whereas structural heating at the board level was conducted using finite‐element method software ( ABAQUS 6.9 ). Findings The simulation showed a complex flow pattern having characteristics of a free‐jet region, stagnation‐flow region, wall jet‐region, recirculation region and vortices. A sharp maximum heat‐transfer coefficient was detected in the stagnation region of the jet, resulting in a spatial variation of local heat transfer on a thermal profile board (TPB). This coefficient affected the temperature distribution in the TPB with different specific heat capacitances and thermal conductivity of the structure. The simulation results were in good agreement with the experimental data and analytical model. The cold region and temperature uniformity (ΔT) increased with increasing complexity of the TPB. The cold region can occur in two possible locations in the TPB. Both occurrences can be related to the flow field of the reflow oven. ΔT of the TPB decreased when the conveyor speed (v) was reduced. A suitable conveyor speed (1.0 cm/s) was determined to maintain ΔT below 10°C, which prevented the thermally critical package from overheating. Practical implications The paper provies a methodology for designing a thermal profile for reflow soldering production. Originality/value The findings provide fundamental guidelines to the thermal‐coupling method at the board and package levels, very useful for accurate control of ΔT at the board and package levels, one of the major requirements in achieving a high degree of reliability for electronic assemblies.

Contactless Thermal Characterization Method of PCB-s Using Different IR Sensor Arrays

Contactless Thermal Characterization Method of PCB-s Using an IR Sensor Array

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Contactless thermal characterization of high temperature test chamber

Thermally Controlled Lab-on-PCB for Biomedical Applications.

Evaluation of Nonintrusive Active Infrared Thermography Technique to Detect Hidden Solder Ball Defects on Plastic Ball Grid Array Components

Temperature Hotspot Detection on Printed Circuit Boards (PCBs) Using Ultrasonic Guided Waves—A Machine Learning Approach

A high-precision thermal imaging approach based on Bayesian inference for EMC diagnosis

High-Throughput Thermophysical Characterization of Semiconductors

An Automatic Test System for a Spaceborne Chip of a Temperature-Sensing Controller

Low-Cost Wireless Temperature Measurement: Design, Manufacture, and Testing of a PCB-Based Wireless Passive Temperature Sensor

Three‐dimensional thermal investigations at board level in a reflow oven using thermal‐coupling method

Temperature measurement of wafers with varying multilayer structures during rapid thermal annealing

Towards on-chip time-resolved thermal mapping with micro-/nanosensor arrays

A Coupled Thermoreflectance Thermography Experimental System and Ultra-Fast Adaptive Computational Engine for the Complete Thermal Characterization of Three-Dimensional Electronic Devices: Validation

Analytical Prediction of the Thermal Behavior of Semiconductor Power Devices from Room-Temperature I–V Measurements

Component-wise Power Estimation of Electrical Devices Using Thermal Imaging

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

Contact measurement of skin temperature using a wearable two-channel PPG optical sensor supplemented by thermometers

Infrared thermal imaging high-precision temperature measurement technology

Non-invasive measurement of the temperature field of a phase change material (PCM) using thermal imaging