Patterned Laser-Induced Graphene Enabling a High-Performance Gas Sensing Split-Ring Resonator
Kishor Kumar Adhikari,Luqman Ali,Jie Wei,Yang Yi,Xiaocong Tang,Zheyi Li,Ju Gao,Liangzhong Mei,Yishun Qu,Junli Yin,Cong Wang
DOI: https://doi.org/10.1016/j.cej.2024.155984
IF: 15.1
2024-01-01
Chemical Engineering Journal
Abstract:The outstanding potential of microwave resonator-based energy-efficient gas sensors has been overshadowed by their underperforming gas sensing capabilities, especially insignificant sensitivity to detect low-concentration volatile organic compounds (VOCs). This unmet challenge persists primarily due to predominant metallic resonator structures, which further limit their wearable applications and pose environmental concerns. This work presents a laser-induced graphene (LIG)-enabled split-ring resonator (SRR) sensor on a flexible polyimide substrate for the rapid and sensitive detection of gaseous VOCs. To implement the sensor, the conductive traces of the SRR were created using a computer-controlled CO2 laser at an optimized power level, thus inducing 48 mu m thick, conductive (24 S/cm) graphene layers on a polyimide substrate. The SRR gas sensor, in which LIG with three-dimensional networks of porosity serves as conductive and even gas-sensitive traces, benefits from a significantly enhanced interaction between the SRR's electromagnetic field and VOC gases. As a proof of concept, a prototype of the LIG-enabled SRR was implemented and mounted on a test fixture. The developed gas sensor operated at a resonant frequency of 1.402 GHz, which exhibited rapid (similar to 17 s) and noticeable shifts when exposed to 200 ppm of different VOCs (acetone, ethanol, methanol, toluene, and isopropyl alcohol). Additionally, the sensor demonstrated a linear correlation between the resonant frequency and acetone gas concentration (1 ppm-200 ppm), with a sensitivity of 188 KHz/ppm. These electromagnetic and gas sensing results suggest that polyimide-derived LIG traces can replace metal microstrip lines in the SRR structure, opening up possibilities for high-performance microwave resonator gas sensors, even suitable for flexible and wearable applications.