Abstract:Underground rock is often subjected to the coupled action of acid sulfate, chloride ion corrosion, and external dynamic disturbance: the degree of corrosion and dynamic load can significantly affect the pore structure and mechanical behavior of rock. To quantify the microscopic pore structure changes and macro-dynamic behavior characteristics of acidified corroded sandstone, first, a mixed acidic solution of NaHSO4 and HCl with different pH values was used for immersion corrosion of sandstone; second, the pore structure of sandstone before and after corrosion was quantitatively evaluated by nuclear magnetic resonance (NMR), dynamic loading tests of corroded sandstone were conducted on an SHPB experimental system and scanning electron microscopy (SEM) was used to observe the morphology of corroded sandstone section; and finally, the mechanism of water–rock interaction and damage and fracture of acid-corroded sandstone were analyzed. The results show that, after acidizing corrosion of sandstone, the macropores increase significantly in number and volume, the boundary of the pore structure tends to be fuzzy; the effective porosity, the number of effective pores, and the total porosity increase significantly; the residual porosity, the number of residual pores, and T2 cut-off value decrease. The proportion accounted for by the elastic stage in stress–strain curves of corroded sandstone is lowered; the proportion accounted for by the plastic yield stage is increased; and post-peak rebound is diminished. With the decrease of pH value, the peak stress on acid-corroded sandstone decreases and the peak strain increases. The peak stress on corroded sandstone is negatively correlated with effective porosity and the number of effective pores, but positively correlated with residual porosity, the number of residual pores, and the T2 cut-off value. The reaction of acidic solution with sandstone minerals causes the free fluid space to increase, the bound fluid space decreases, and the number of pores increases, resulting in a decrease in the dynamic strength of acidified sandstone. The fracture of original sandstone after impact failure has no obvious directionality, and the failure mode of grain is the coexistence of intergranular fracture and trans-granular fracture. The fracture of sandstone after acidizing corrosion is obviously directional after impact damage, and the fracture form is single, which is intergranular fracture. The research results can provide a certain reference for the protection of rock engineering under acidic water chemical environment.

Quantitative Analysis on Tensile Mechanical Properties and Microscopic Characteristics of Acidified Limestone

Experimental Investigation on Microstructure and Surface Morphology Deterioration of Limestone Exposed on Acidic Environment

Effect of Microstructure on Changes to the Pore Structure and Mechanical Properties of Limestone under Acidic Groundwater Corrosion

Microscopic Damage to Limestone under Acidic Conditions: Phenomena and Mechanisms

Experimental Study of Effect of Chemical Corrosion on Strength and Deformation of Hard Brittle Limestone

Study on the mechanical and damage properties of laminated limestone under acid mine drainage dissolution

Damage Time-Dependent Characteristics and Failure Mechanism of Limestone with Different Mineral Compositions Under Acid Hydro-Chemical Solution Erosion

Mechanical properties and damage constitutive model of sandstone after acid corrosion and high temperature treatments

Mechanical Properties and Energy Evolution of Red Sandstone Under the Influence of Acid Corrosion

Mechanism of Damage and Deterioration of Red Sandstone in South China under Different pH Treatments

Study on Mechanical Properties and Weakening Mechanism of Acid Corrosion Lamprophyre

Study on the Effect of Dry–Wet Cycles on Dynamic Mechanical Properties of Sandstone Under Sulfuric Acid Solution

Effects of temperature and acid solution on the physical and tensile mechanical properties of red sandstones

Experimental Study on Uniaxial Compression Failure Characteristics and Mechanical Properties of Composite Aquiclude Rock

Aging deterioration of mechanical properties on coal-rock combinations considering hydro-chemical corrosion

Effects of Acid Sulfate and Chloride Ion on the Pore Structure and Mechanical Properties of Sandstone Under Dynamic Loading

Study on rock strength weakening in multi-stage acid fracturing using continuous strength test

Influences of rock microstructure on acid dissolution at a dolomite surface

Study on the Performance Degradation of Sandstone under Acidification

Study on Strength and Microstructure of Cement Pastes Containing Limestone Powder under Flowing Acid Solution Condition

Aging Features and Strength Model of Diorite’s Damage Considering Acidization