Abstract:110 kV power cable usually takes the form of single core, it is a general phenomenon that there is induced voltage in metal shield. For long cable, three segments transposition is often used to decrease the induced voltage in metal shield of high voltage power cable, but since city construction and other reasons, power cable is rebuilt more and more frequently, the length of three segments will be unequal while the power cable rebuilt, it will make the induced voltage in metal shield unbalanced, and produce the circulating current in metal shield. Through theoretical analysis of the induced voltage, the paper presents the mathematic model of induced voltage in metal shield under arbitrary arrangement ways of power cable; according to the model, simulating calculation is carried out, at the end of cable, the compensating device is installed to balance( counteract) the induced voltage and restrain circulating current. The paper presents that making use of standard ball gap to protect cable metal shield and its compensating unit, so as to prevent metal shield and compensating unit from severe over-voltage caused by short or thunder. The compensating device developed in the paper has been taken a great deal of spot tests in power company, the result has indicated that the method can reduce the induced voltage in metal shield effectively, thus the circulating current and cable losses can be reduced. At present, the device has been installed on spot for pilot running.

Review of Researches on Power Cables Ampacity Calculation

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Calculation of Ampacity of Double-loop XLPE Cables in Trenches Based on Multiphysics Simulation

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Research on Dynamic and Thermal Effects Based on the Calculation of the Short-Circuit Current in Low-Voltage DC Distribution Systems for Civil Buildings

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Research on the Improvement of Cable Ampacity in Dense Cable Trench

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

An improved AMG-based method for fast power grid analysis

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Analysis on three-core power cable temperature field and ampacity model under typical laying environment

Long-Term Ampacity Prediction Method for Cable Intermediate Joints Based on the Prophet Model

Review of recent research towards power cable life cycle management

Simulation and Calculation of Temperature Field and Current-Carrying Capacity of Power Cables under Different Laying Methods

Calculation and Analysis of 220kV Cross-River Cable Carrying Capacity Considering Complex Environments, Part I — Analysis of Thermal Problems for the Entry Section of Overhead Transmission Line to Underground Cable

Research on Key Factors to Determine the Corrected Ampacity of Multicore Photoelectric Composite Cables

An improved analytical thermal rating method for cables installed in short-conduits

Research on loss characteristics and current-carrying capacity of low-smoke halogen-free cables