Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Influence of Zr Element on the Atomic Structure of Al-Cu Alloy Liquid

On the atomic structure of Zr–Ni and Zr–Ni–Al metallic glasses

The characterisation of atomic structure and glass-forming ability of the Zr–Cu–Co metallic glasses studied by molecular dynamics simulations

Effects of minor addition of Al and Ag elements on the atomic structure and mechanical property of ZrCu-based metallic glasses

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Molecular dynamics simulation of minor Zr addition on short and medium-range orders of Cu-Zr metallic glass

Influence of La on the atomic structure of Al Cu alloy liquid

Effect of Trace Zr on Microstructure and Hardness of Al-Zn-Mg-Cu Alloy Prepared under Supergravity

Mechanism of Ag and Al on improving the glass forming ability of CuZr-based alloys

Effect of Al Composition Tuning on Properties and Structure in Zr-Co-Al Metallic Glass

Effect of Alloying Elements on the Short-Range Orders and Atomic Diffusion Behavior of Liquid Al−9Si Cast Alloys

Relationship of Glass Forming Ability and Local Structural Properties of Liquid Cu-Zr Alloys

Formation and structure of Cu-Zr-Al ternary metallic glasses investigated by ion beam mixing and calculation

Composition reign favored for the formation of CuZrAl amorphous phases investigated by ion beam mixing

Glass-formation and atomic structures of Cux(Zr 0.22Hf0.78)1-x and (Cu0.61Hf 0.39)1-xZrx alloys investigated by Monte Carlo simulation

Atomic Structure and Glass Forming Ability of Cu46zr46al8 Bulk Metallic Glass

Effects of Zr and Mg alloying on microstructure and properties of Cu-Cr-Si alloys

Impact of atomic packing and electronic structure on icosahedral short-range order and glass-forming ability of Zr–Cu metallic glasses

Atomic Structure in Al-Doped Multicomponent Bulk Metallic Glass

Comparative study of local atomic structures in Zr2CuxNi1−x (x = 0, 0.5, 1) metallic glasses

Glass Forming Abilities of Binary Cu100−xZrx (34, 35.5, and 38.2 At. %) Metallic Glasses: A LAMMPS Study