Selective laser melting of 316L–CuCrZr bimetallic structure via IN718 transition layer
Zhonghua Li,Zezhou Kuai,Bin Liu,Yanlei Chen,Huodong Li,Yanyang Wang,Wenjuan Huo,Min Wei,Huirong Yang,Peikang Bai
DOI: https://doi.org/10.1016/j.jmrt.2023.06.196
IF: 6.267
2023-07-01
Journal of Materials Research and Technology
Abstract:Steel/copper bimetallic structural materials combine the good strength and corrosion resistance of steel with the high thermal and wear resistance of copper and have been widely used in fusion reactors, conformal cooling channels, and heat transfer devices. Due to the large difference in thermal and physical properties of steel and copper, and the immiscibility of steel and copper, the bonding interface usually produces a large residual stress during the forming process, which leads to the formation of interface cracks. In order to combine CuCrZr with 316L stainless steel by using selective laser melting technology, IN718 was deposited on 316L stainless steel as a transition layer. The effects of the IN718 alloy transition layer on the microstructure, phase composition, and mechanical properties of the interface of 316L–CuCrZr were studied. IN718–316L had no defects such as pores and cracks at the interface and achieved good metallurgical bonding. The IN718–CuCrZr interface area and copper side had round key holes and relatively small pores. In the solidification process, IN718 preferentially solidified in the shape of fine particles, providing a nucleation point for the copper grain, thus forming equiaxed grains because of the high cooling rate of the interface. No macroscopic defects were observed at the bonding position of the 316L–IN718–CuCrZr samples, and the elements at the interface were fully diffused by each other. The tensile strength of the 316L–IN718–CuCrZr samples reached 403 MPa, and the interface strength was significantly improved upon the addition of the transition layer.
materials science, multidisciplinary,metallurgy & metallurgical engineering