Abstract:A series of MnCo/Cu-ZSM-5 (MnCo/Cu-Z) catalysts with different Mn/Co ratios for the selective catalytic reduction (SCR) of NO with NH3 were prepared by the combination of ion exchange and impregnation. The physicochemical properties of the catalysts were investigated by N2 adsorption/desorption, X-ray diffraction (XRD), temperature-programmed reduction with hydrogen (H2-TPR), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption of NOx (NOx-TPD) and NH3 (NH3-TPD), and the diffuse reflectance infrared Fourier transform (DRIFT) technique was employed for the detection of intermediate species and the study of the mechanism. The introduction of Mn and Co boosts the catalytic activity of the Cu-Z catalyst at a temperature below 200 °C, and the optimum activity was obtained over the Mn1Co2/Cu-Z catalyst. The enrichment of the high-valent metal ion on the catalyst surface and the improvement in the reducibility of metal oxide are responsible for the elevation in the catalytic activity of MnCo/Cu-Z. The bridged and bidentate modes are the prevailing nitrate species on the Cu-Z and MnCo/Z catalysts, respectively, and both of them were detected over the MnCo/Cu-Z catalyst. Furthermore, the DRIFT spectroscopy (DRIFTS) results indicate that, at 150 °C, the bridged nitrate can react with the adsorbed ammonia species, but the bidentate nitrate fails to do. The SCR reaction over the Cu-Z catalyst follows the Eley–Rideal and Langmuir–Hinshelwood mechanisms simultaneously at 150 °C, whereas an overwhelming dominance of the Eley–Rideal mechanism is identified for the MnCo/Z catalyst. As to the SCR mechanism on the MnCo/Cu-Z catalyst, it combines the features of Cu/Z and Mn1Co2/Z.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c01172?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c01172</a>.Physical properties of catalysts; peak positions and assignments in the DRIFT Spectra; effects of H2O on NOx conversion; effects of H2O on the stability of catalysts; EDS element mapping of catalysts; and relative amount of surface acid sites (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c01172/suppl_file/cs1c01172_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Surface Tailoring on Bifunctional CuOx/MnO2 Catalyst to Promote the Selective Catalytic Reduction of NO with NH3 and Oxidation of CO with O2

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

Simultaneously achieving selective catalytic reduction of NOx with NH3 and catalytic oxidation of CO with O2 over one finely optimized bifunctional catalyst Mn2Cu1Al1Ox at low temperatures

Interactions between CO oxidation and selective catalytic reduction of NO with NH3 over Mn-based catalysts

Mechanism of NO reduction by NH3 over MnCuOx catalysts and the influence mechanism of CO

Bifunctional Catalysts V-Cu/TiO2 for Selective Catalytic Reduction of NOx and CO Oxidation under Oxygen-Rich Conditions

Bifunctional Catalyst of CuMn-HZSM-5 for Selective Catalytic Reduction of NO and CO Oxidation under Oxygen Atmosphere

Efficient simultaneous removal of NOx and CO at low temperatures over integrated Mn2Co1Ox/iron mesh monolithic catalyst via NH3-SCR coupling with CO oxidation reactions

Novel insights for simultaneous NOx and CO Removal: Cu+-Sm3+-Ov-Ti4+ asymmetric active site promoting NH3-SCR coupled with CO oxidation reaction

Selective catalytic reduction of nitric oxide with carbon monoxide over alumina-pellet-supported catalysts in the presence of excess oxygen

Bifunctional Mn-Cu-CeOx/γ-Al2O3 catalysts for low-temperature simultaneous removal of NOx and CO

Bifunctional catalysts V-Cu/TiO 2 for selective catalytic reduction of NO x and CO oxidation under oxygen-rich conditions

Spinel Structured CoaMnbOx Mixed Oxide Catalyst for the Selective Catalytic Reduction of NOx with NH3

Boosting RuO2 Surface Reactivity by Cu Active Sites over Ru/Cu-SSZ-13 for Simultaneous Catalytic Oxidation of CO and NH3

Synthesis, characterization and catalytic performances of Cu- and Mn-containing ordered mesoporous carbons for the selective catalytic reduction of NO with NH3

Cu-ZSM-5 Catalyst Impregnated with Mn–Co Oxide for the Selected Catalytic Reduction of NO: Physicochemical Property–Catalytic Activity Relationship and In Situ DRIFTS Study for the Reaction Mechanism

Unraveling the morphology and crystal plane dependence of bifunctional MnO2 catalyst for simultaneous removal of NO and CO at low temperature

Mechanistic Investigation of the Enhanced SO2 Resistance of Co-modified MnOx Catalyst for the Selective Catalytic Reduction of NOx by NH3

Ni-Mn Bi-Metal Oxide Catalysts for the Low Temperature SCR Removal of NO with NH3

Mn-Modified CuO, CuFe2O4, and Γ-Fe2o3 Three-Phase Strong Synergistic Coexistence Catalyst System for NO Reduction by CO with a Wider Active Window.

Recent Advances of Cu-Based Catalysts for NO Reduction by CO under O2-Containing Conditions