Abstract:As a major gas pollution source, nitrogen oxide (NO x , NO + NO 2 ) poses a serious threat to the natural environment and human health. Therefore, it is imperative to develop high-efficiency detection equipment for in-situ detection of NO x . The emission sources of NO x are mainly industrial exhaust gas and automobile exhaust gas. The gas temperature is relatively high and the composition is relatively complicated. The solid electrolyte-based gas sensor can realize high selectivity and high sensitivity detection of NO x at high temperature. In this study, a Co3O4/Cr2O3/YSZ composite material was used as the sensing electrode (SE) and YSZ was used as the solid electrolyte to prepare the impedance type of NO x sensor. The sensor was characterized by XRD, SEM and EDX, and the NO x sensing performance at high temperature was systematically studied. The results show that the Co3O4/Cr2O3/YSZ sensing electrode with particle size of about 200 nm has a high specific surface area due to the loose and porous structure, which is conducive to gas diffusion and mass transfer. The sensor shows a good response-recovery characteristic to NO x , and the concentration has little influence on the sensor. In addition, the sensor shows good reproducibility, stability, and selectivity. In order to further apply the sensor to in-situ detection of NO x under high temperature, we successfully prepared a novel self heated sensor. The sensor shows good sensitivity characteristics, and the concentration detection range is - . In addition, the self-heating sensor shows good reproducibility. This research will- provide new ideas for in-situ detection of NO x gas at high temperature.

THE PERFORMANCE EVALUATION OF A FULLY SOLID STATE SOx(x=2,3)GAS SENSOR

A Fully Solid-State SOx (x = 2,3) Gas Sensor Utilizing Ag-ß″-alumina As Solid Electrolyte

Increasing the Sensitivity of an Amperometric, YSZ-based Total-Nox Sensor by Opening the Gas Diffusion Pathways in a Porous La0.8Sr0.2MnO3 Electrode

Electrochemical Sox (X=2 Or 3) Gas Sensor Based On Solid Electrolytes

Au thin-film electrodes based potentiometric CO2 sensor using Li3PO4 as both the reference material and the solid electrolyte

Response Characteristics of A Potentiometric Co2 Gas Sensor Based on Li3po4 Solid Electrolyte Using Au Film As the Electrodes

YSZ-Based Mixed Potential Type Sensors Utilizing Pd-doped SrFeO 3 Perovskite Sensing Electrode to Monitor Sulfur Dioxide Emission

Gas-Sensing Performance of Core-shell SnO2-based Chemiresistive MEMS Sensor for H2S Detection under Vacuum

Solid-Electrolyte Amperometric Sensor for Simultaneous Measurement of CO and CO2 in Nitrogen

High Performance H 2 S Sensor Based on Ordered Fe 2 O 3 /Ti 3 C 2 Nanostructure at Room Temperature

High Performance H2S Sensor Based on Ordered Fe2O3/Ti3C2 Nanostructure at Room Temperature

Building Feedback-Regulation System Through Atomic Design for Highly Active SO2 Sensing

Ordered Mesoporous Tin Oxide Semiconductors with Large Pores and Crystallized Walls for High-Performance Gas Sensing

Research on Preparation and Performance of a New Solid Electrolyte Based Nitrogen Oxides Sensor

Simulation of gas sensing mechanism of porous metal oxide semiconductor sensor based on finite element analysis

New Sensor for Gases Dissolved in Transformer Oil Based on Solid Oxide Fuel Cell

Preparation of H-2 and Lpg Gas Sensor

A review of high-temperature electrochemical sensors based on stabilized zirconia

Pressure-Compensated Fiber-Optic Photoacoustic Sensors for Trace SO 2 Analysis in Gas Insulation Equipment

Accelerating the Gas–Solid Interactions for Conductometric Gas Sensors: Impacting Factors and Improvement Strategies

1D Metal Oxide Semiconductor Materials for Chemiresistive Gas Sensors: A Review