Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Experimental Study on Current Distribution in Parallel-Connected Solid Oxide Fuel Cell Strings

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Numerical Simulation of Cell-to-cell Performance Variation Within a Syngas-Fuelled Planar Solid Oxide Fuel Cell Stack

Anode-Versus Cathode-Supported Solid Oxide Fuel Cell: Effect of Cell Design on the Stack Performance

Numerical Simulation of Electrical Performance and Distribution of SOFC Stacks with Different Manifold Arrangement

Investigations on Single Chamber Solid Oxide Fuel Cells: from Single Cell to Micro-Stack

Numerical multi-physical optimization of operating condition and current collecting setup for large-area solid oxide fuel cells

Performance Comparison of Cocurrent and Countercurrent Flow Solid Oxide Fuel Cells

Flow Distribution Analyzing for the Solid Oxide Fuel Cell Short Stacks with Rectangular and Discrete Cylindrical Rib Configurations

Investigating on the Flow Distribution of a Planar Solid Oxide Fuel Cell Stack

Modeling and analysis of the multiphysics transport parameters of a kilowatt-class multistack module of reversible solid oxide cells

Numerical study on a novel SOFC with bi-layer interconnector

Experimental investigation of temperature distribution in solid oxide fuel cells

Investigation on the Performance Heterogeneity Within a Fuel Cell Stack Considering Non-Isopotential of Bipolar Plates

The Progress on Research and Development of Tubular Solid Oxide Fuel Cell Stacks

Flow uniformity analysis and optimization of a 60-cell external manifold solid oxide cell stack with bottom-accesses

The Uniformity and Consistency Analysis of a Fuel Cell Stack with Multipoint Voltage-Monitoring Method

Numerical Investigation of Air Flow Characteristics for a Compact 5 × 10 Array Tubular Segmented-in-series Solid Oxide Fuel Cell Stack

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells