Abstract:Nowadays, high-frequency switching power amplifiers (SPA) have been studied widely; bulk of the researches were focused on audio power amplifiers. In active magnetic bearing (AMB) systems, high-frequency electromagnetic excitation caused by rotor imbalance can affect the performance of the SPA, so the traditional SPA cannot meet the requirements of the AMB systems. Therefore, on the premise of ensuring larger power, the frequency of the SPA should be improved to ensure the normal operation of the AMB system. Two-level pulsewidth modulation (PWM) current-mode SPAs are widely used in AMB systems. In order to broaden the bandwidth and to reduce the average steady-state error current, SiC power devices based SPA with a high bus voltage and a high switching frequency was designed. The basic principle and the linearized control model of SPAs are introduced. Then, the duty ratio stability and average steady-state error current of the SPAs are analyzed based on the output ripple current. When the PWM modulator is designed by either the discrete devices or the integrated chips, the critical gains to ensure the duty ratio stability are, respectively, analyzed based on the slope matching and the nonideal characteristic of operational amplifiers. Hence, two methods to reduce the average steady-state error current are proposed, respectively. One is to adjust the offset voltage of triangular carrier for the P controller, the other is to use a proportional integral (PI) controller. The offset adjusting method allows the SPA to achieve better dynamic performance and wider bandwidth. The proportional integral (PI) controller can reduce the average steady-state error current but narrows the bandwidth. Finally, the experiment results are in good agreement with the theoretical analyses.

Design and Stability Analysis of the Variable-Sawtooth-Based PWM Controller for the AC-Coupled Envelope Tracking Supply Modulator

High-stability controller on CC or CV output applications

A Wideband Hybrid Envelope Tracking Supply Modulator with Slew-Rate-Enhanced Linear Amplifier

An Open-loop Digitally Controlled Supply Modulator for Wideband Envelope Tracking

PWM Modulation Methods of PWM Rectifiers in WECS

Discrete Pulse Frequency Modulation Control with Sliding-Mode Implementation on Llc Resonant Dc/Dc Converter Via Input-Output Linearisation

Analysis on the Stability of Two-Level Current Mode Switching Power Amplifiers

Duty Ratio Stability and Average Steady-State Error of Two-Level Current-Mode Wide-Bandwidth Switching Power Amplifiers

Multiple Fourier Series-based Modeling and Stability Analysis of the Three-Phase Pulse-Width-Modulated VSC

Multiple Fourier Series-Based Modeling and Stability Analysis of the Three-Phase Pulsewidth-Modulated VSC

Analysis and Design of Quasi-Resonant Supply Based on NCP1337

An Open Loop Digitally Controlled Hybrid Supply Modulator Achieving High Efficiency for Envelope Tracking with Baseband Up to 200-Mhz

A Low-Pass Sense and Control Circuit for Switching Amplifier in Wideband Hybrid Envelope Tracking Supply Modulator

A stability control strategy for PWM converter with undamped LCL-filter

An Improved Modulation Technique with Minimum Switching Actions within One PWM cycle for Open-End Winding PMSM System with Isolated DC BUS

Stabilization for a class of strict-feedback nonlinear systems via the PWM control law.

A 200mhz Bandwidth 84% Peak Efficiency AC-Coupled Envelope Tracking Supply Modulator with 10mhz Constant Switching Frequency

A Highly-Applicable Supply Modulator with A Highly-Linear Envelope Detector for Wcdma Envelope-Tracking Applications

A Sub-harmonic Oscillation Elimination Method with PI Modulation in PSR Flyback Converter

A new oscillation controller design and induction machine stability analysis of volts/Hz based industrial adjustable speed drives

Design and Analysis of Highly Efficient Led Power Supply with Pfc-LLC Topology