Abstract:Depleted gas reservoir type underground gas storage is the most widely distributed gas storage in the world. Due to the complex geological conditions and frequent gas injection and production operations, it is prone to the wellbore integrity failures leading to hazards such as annular pressure. To protect the wellbore integrity and contain the escape of gas to subterranean formations or surface, a finite element model is developed to study the wellbore integrity change. This model simulates the typical gas injection and production processes of gas storage with complex geological conditions and non-uniform ground stress. A new comprehensive method considering complex well conditions was developed to simulate the wellbore integrity failure process more realistically. This model can predict the wellbore integrity failure and high-risk areas during the gas injection and production processes. The simulation results indicate that the cement shear failure sections are mainly concentrated near the upper and lower boundaries of the formation interlayer during the gas injection process, and the distribution area and trend of the shear failure areas are the same as the gas production process. The most common cement tensile failure sections during the gas injection process all occur on the inner side of the cement in the direction of maximum ground stress during the gas injection process. The highest effective (Von Mises) stress area of the casing is mainly concentrated in the upper and lower boundary zone of the formation interlayer during the gas injection process. And the highest Von Mises stress sections are mainly distributed in the direction of the minimum ground stress near the formation interlayer lower boundary inside the casing, which is similar to the distribution in gas production process. The first cohesive failure position and final failure distribution result of cement inner interface both appear in the depth range of the formation interlayer. The cement outer interface's first and final failure areas are all concentrated on the lower boundary of the formation interlayer and consistent with the direction of the maximum ground stress. The cement inner interface failure occurred earlier but not as significant as the outer interface failure, which occurred later but the failure range was large in this case. Practical guidelines and solutions derived from the simulation results can be useful for improved wellbore integrity protection in field applications.

Offshore Oilfield Gas Injection Wells Erosion Study and Evaluation

Study on Erosion Model Optimization and Damage Law of Coiled Tubing

Experimental and Numerical Simulation Analyses of Elbow Erosion in Surface Process of Deepwater Gas Well Testing

Corrosion Analysis and Prevention of Tubing Nipples in Four Wells

Experimental Study on Flow-Induced Corrosion of Casing and Tubing Steel for Heavy Oil Thermal Recovery Wells

Corrosion Status of Oil Well Pipe and Anti-corrosion Technology Development

Experimental Study on CO2 Corrosion of Super 13Cr Integrated Tubing with Erosion Damage

Comprehensive analysis of the effect of structural parameters on erosion wear, structural stress, and deformation of high-pressure double-elbow in shale-gas fracturing

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

Analysis of depleted gas reservoir underground gas storage wellbore integrity change during gas injection and production processes

Failure Analysis of Tubing Collapse in a Gas Well

The erosion-corrosion behaviors of the full-scale Ni-P and Ni-Cu-NiW internal coating tubing

Response analysis and safety control of tubing vibration in HPHT and ultra-deep gas wells

Study on the Erosion of Choke Valves in High-Pressure, High-Temperature Gas Wells

Cause Analysis of Tubing Flattening in an Oil Well

Study on Fracture Failure Behavior of Super 13Cr Tubing Caused by Deposited Corrosion

Experimental Study On The Mechanics Of A Coiled Tubing Working Within A Marine Riser Under The Affection Of Marine Loads

Experimental study on the influence of bending and straightening cycles for non-destructive and destructive coiled tubing

Research on the Erosion Law and Protective Measures of L360N Steel for Surface Pipelines Used in Shale Gas Extraction

Multistring analysis of wellhead movement and uncemented casing strength in offshore oil and gas wells

Study on Erosion Wear Law and Anti-Erosion Ability Optimization of Wellhead Four-Way