Abstract:By incorporating 1‐cyclohexene‐1‐ethanamine cation into the host 1‐phenylbutylamine cation spacer and fabricating mixed‐cations quasi‐2D perovskites, a homogeneous phase distribution in quasi‐2D perovskite films is achieved through precise tuning of the phase formation energy. The resulting PeLEDs exhibit remarkable performance with an external quantum efficiency (EQE) of 5.8% at 467 nm. Organic and inorganic hybrid perovskites are a class of solution‐processable semiconductors that hold significant promise for light‐emitting diode applications. However, the development of efficient blue perovskite light‐emitting diodes (PeLEDs) has remained a critical challenge. Although significant advancements have been achieved in the development of sky‐blue PeLEDs, the performance of pure‐blue and deep‐blue PeLEDs still lags. In this manuscript, by incorporating 1‐cyclohexene‐1‐ethanamine cation (CEA+) into the host 1‐phenylbutylamine cation (PBA+) spacer and fabricating mixed‐cations quasi‐2D perovskites, a homogeneous phase distribution in quasi‐2D perovskite films is achieved through precise tuning of the phase formation energy. The resulting PeLEDs exhibit remarkable performance with an external quantum efficiency (EQE) of 5.8% at 467 nm, which is one of the highest EQEs among the deep‐blue light quasi‐2D PeLED devices with emission wavelengths below 470 nm, Additionally, the device demonstrates a half‐lifetime of ≈ 25 min. Furthermore, the PeLEDs utilizing mixed‐cation perovskite exhibit a stable electroluminescence (EL) spectrum under varying voltage biases, even when the chlorine content in the halogen sites reaches as high as 30%. Overall, this work offers a novel and promising avenue to achieve both high EQE and a stable EL spectrum in blue‐light quasi‐2D PeLEDs.

Efficient and High-Radiance Silicon-Based Perovskite Light-Emitting Diodes Through Phase Segregation Control

Phase Stabilization for High-Performance Perovskite Light-Emitting Diodes

Multifunctional Additives for Bright, Efficient and Stable Lead-bromide Perovskite LEDs

Tailoring the 2D/3D Phase Segregation for Highly Efficient Si-Based Perovskite Light-Emitting Diodes

Perovskite-molecule Composite Thin Films for Efficient and Stable Light-Emitting Diodes.

Efficient Quasi-2D Perovskite Light-Emitting Diodes Enabled by Regulating Phase Distribution with a Fluorinated Organic Cation

Formation of Distributed Local Heterojunction to Enhance NIR Emission Due to the Effective Carrier Transfer

Unraveling Size-Dependent Ion-Migration for Stable Mixed-Halide Perovskite Light-Emitting Diodes

Highly Efficient Red Perovskite Light‐Emitting Diodes with Reduced Efficiency Roll‐Off Enabled by Manipulating Crystallization of Quasi‐2D Perovskites

Performance-optimized and Phase Purity-Improved High-N Quasi-Two-dimensional Perovskite for Green Light-Emitting Diodes

Rational Interface Engineering for Efficient Flexible Perovskite Light-Emitting Diodes.

Improved Efficiency for Silicon‐Based Perovskite Light‐Emitting Diodes Via Interfacial Hydrophilic Modification

Grain orientation management and recombination suppression for ultra-stable PeLEDs with record brightness

Exploiting a Multiphase Pure Formamidinium Lead Perovskite for Efficient Green-Light-Emitting Diodes.

Co‐Interlayer Engineering for Homogenous Phase Quasi‐2‐D Perovskite and High‐Performance Deep‐Blue Light‐Emitting Diodes

Highly bright and stable single-crystal perovskite light-emitting diodes

Ions-induced Assembly of Perovskite Nanocomposites for Highly Efficient Light-Emitting Diodes with EQE Exceeding 30

Inhibiting Cation Segregation to Enable Highly Efficient Perovskite Light‐Emitting Diodes

A Strategy for Architecture Design of Crystalline Perovskite Light-Emitting Diodes with High Performance.

High-Performance All-Inorganic Architecture Perovskite Light-Emitting Diodes Based on Tens-of-Nanometers-Sized CsPbBr3 Emitters in a Carrier-Confined Heterostructure

Highly Efficient Visible Colloidal Lead-Halide Perovskite Nanocrystal Light-Emitting Diodes