Abstract:Surface texturing is an effective technology for enhancing lubrication and anti-wear properties through hydrodynamic effects and secondary lubrication. In this study, two types of variable-depth groove textures were designed to enhance the lubrication performance of friction pairs. Based on theoretical analysis, the coefficient of friction (COF), wear characteristics, and triboelectric open-circuit voltages produced by different textures were evaluated in a series of experiments. Using a friction testing setup, scanning electron microscopy, energy dispersive spectrometry, an electrometer (Keithley 6514), Raman spectroscopy, surface microtopography, and lubrication mechanisms were revealed. First, two types of variable-depth groove textures were designed based on computational fluid dynamics. Second, SiC samples with these textures were fabricated using laser surface texturing technology, and ball–disk rotary friction experiments were performed. During the friction tests, the shallow inner and deep outer (SDT) groove textures exhibited a lower COF at medium and low speeds under varying loads. Finally, the lubrication mechanism was attributed to the synergistic effect of four factors: the hydrodynamic effect of the lubricant, enhanced ability of debris expulsion, oxide tribofilms at the interface, and polarization electric field generated at the solid–liquid interfaces between the lubricant and friction pair. The results indicate that the minimum COF of the SDT texture can be reduced to 0.025. These insights offer valuable guidance for design methods and new lubrication mechanisms for enhancing the lubrication and anti-wear properties of friction pairs in mechanical systems.

Effect of Squamous Textured SiC on the Dry-Sliding Tribological Properties of Graphite Asperities

Tribological Behavior of Squamous Textured SiC Sliding Against Graphite under Mixed Lubrication

Wear Evolution of Graphite Asperities on Dry-Sliding with the Squamous Textured SiC

Numerical Simulation and Experimental Investigation on Tribological Performance of SiC Surface with Squamous Groove Micro Texture

Enhancing the Anti-Wear Performance of Graphene Sheets Embedded Carbon Films Through Interface Nanotexture Fabricated on the Substrate

Effect of ceramic surface texture on the tribological property of ceramics and carbon fiber reinforced silicon carbide ceramic matrix composite (C/SiC)

Effect of Texture Parameters on the Tribological Properties of Spheroidal Graphite Cast Iron Groove-Textured Surface under Sand-Containing Oil Lubrication Conditions

Effect of Graphite Particle Reinforcement on Dry Sliding Wear of SiC/Gr/Al Composites

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication

Effects of Surface Roughness Parameters on Tribological Performance for Micro-textured Eutectic Aluminum-Silicon Alloy

Atomic-Scale Understanding on the Tribological Behavior of Amorphous Carbon Films under Different Contact Pressures and Surface Textured Shapes

Enhancement of Tribological Properties in Siliconized Graphite Via Hierarchically Hybrid SiC/C Composite

Tribological Properties of Si-Doped Graphite-Like Amorphous Carbon Film of PEEK Rubbing with Different Counterparts in SBF Medium

Anisotropic Tribological Behavior of LSI Based 2.5D Needle-Punched Carbon Fiber Reinforced Cf/C–SiC Composites

Wear Mechanism and Three-phase Synergistic Effect of Self-mated SiC/Si/Graphite Composites in Unlubricated Sliding

Study on the Friction-Reducing Mechanisms of Surface Texture Cemented Carbide under Dry Sliding

EFFECTS OF POINT GRINDING SURFACE TEXTURE ON CONTACT AND WEAR CHARACTERISTICS UNDER DRY SLIDING CONDITION

Study on the Mutual Influence of Surface Roughness and Texture Features of Rough-Textured Surfaces on the Tribological Properties

Effect of the mass fraction of Si on friction and wear properties of C/C - SiC composites

Experimental study on the tribological performance of fractal-like textured surface under mixed lubrication conditions

Effect of Surface Texturing on Friction Properties of WC/Co Cemented Carbide