Effect of the mass fraction of Si on friction and wear properties of C/C - SiC composites

Ying LIU,Wei YANG,Yinfei YIN,Guanxi LI
DOI: https://doi.org/10.3969/j.issn.1006-0456.2016.01.014
2016-01-01
Abstract:With PAN﹣based carbon fiber needled felt as a perform,C / C - SiC friction materials were fabricated by infiltrating Si into C / C porous performs,which were prepared by chemical vapor infiltration. Tribological proper﹣ties were measured through XD﹣MSM type constant﹣speed friction tester. The effects of different Si content on tribo﹣logical properties of C / C - SiC friction material were investigated. Worn surface morphology was observed by VK -X200 three﹣dimensional laser scanning microscope,and wear mechanism was discussed. The results showed that with the increase of Si content,the hardness and impact strength of C / C - SiC friction material was increased gradu﹣ally,and open porosity was decreased gradually. The friction material wear in the form consists of a single wear mechanism of abrasive wear into a mixing wear mechanism of abrasive wear and adhesive wear. Physical and me﹣chanical properties of C / C - SiC friction material were greater when the mass fraction of Si was 33. 49% ,and it has a larger coefficient of friction,a smaller wear rate and a better tribological properties.
What problem does this paper attempt to address?