Abstract:This paper investigates the buckling behaviour and load-carrying capacity of G550 high strength cold-formed steel built-up section columns under axial compression through experiments and numerical simulations. Two types of built-up sectional profiles were formed, which were defined as built-up OI-section and built-up CB-section. Each built-up OI-section member is formed by connecting two cold-formed steel C-section members in a back-to-back manner using self-drilling screws, while each built-up CB-section member consists of a cold-formed steel C-section member and a cold-formed steel U-section member, which are connected in a face-to-face manner by self-drilling screws. The experimental programme included tensile coupon tests, initial geometric imperfection measurements and 20 pin-ended column compression tests. In the numerical modelling programme, finite element models were developed and validated against the experimental results, and then used for parametric analyses to generate a total of 250 numerical data with different cross-section dimensions and member lengths. Based on the experimental and numerical data, the accuracy of both the effective width method and the direct strength method for predicting the strengths of G550 high strength cold-formed steel built-up section columns, as set out in the American Specification, was evaluated. The evaluation results indicated that both the effective width method and direct strength method provided accurate and consistent failure load predictions for G550 high strength cold-formed steel built-up OI-section columns on average, but with some unsafe failure load predictions, while the predicted failure loads were inaccurate, scattered and conservative for G550 high strength cold-formed steel built-up CB-section columns. Moreover, the effective width method and direct strength method yielded a similar level of design consistency for G550 cold-formed steel built-up section columns, but the direct strength method resulted in more accurate and less conservative failure load predictions than the effective width method. The modifications to the codified DSM equations were proposed for G550 high strength cold-formed steel built-up section columns and shown to provide improved predictions of failure load over the design codes.

Compressive Behavior of Novel Cold-Formed Steel Built-Up Closed L-shaped Section Columns

Seismic Behavior of Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

Cold-Formed Steel Built-Up Closed Sections With Intermediate Stiffeners

Compression Tests Of Cold-Formed Steel C- And Z-Sections With Different Stiffeners

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Design of Cold-Formed Steel Built-Up Closed Sections with Intermediate Stiffeners

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Numerical Investigation on Compressive Performance of CFST Columns with Encased Built-Up Lattice-Angles

Simplified design method of cold-formed steel columns with built-up box sections

Testing, numerical modelling and design of G550 high strength cold-formed steel built-up section columns

Axial compression behavior of prefabricated L-section thin concrete encased steel short columns

Experimental and numerical investigation on the behaviour of square concrete-filled cold-formed double-skin steel stiffened tubular short columns

Axial compression behavior of prefabricated cruciform-section thin-concrete-encased steel short column

Distortional buckling behavior of cold-formed steel built-up closed section columns

Experimental investigation of cold-formed stainless steel built-up closed section stub columns

Experimental Investigation of Special-Shaped Concrete-Filled Square Steel Tube Composite Columns with Steel Hoops under Axial Loads

Performance of steel-reinforced square CFST stub columns loaded in axial compression: Experiments

Axial Compression Behaviour of Circular Concrete-Filled Stainless-Clad Bimetallic Steel Tubular Stub Columns

Test and design of rectangular steel-reinforced concrete-filled stainless steel tubular short columns

Strength and behavior of axially and eccentrically loaded built-up closed sections using four cold-formed steel open sections