Abstract:When thin-walled composite cylindrical shells are subjected to combined loads, not only will they buckle, but they could fail under overstressing. Buckling-failure and stress-failure are two types of failure that compete mutually, and if one of them occurs, the structure loses its ability to carry the load. However, there is a lack of study, and very little attention was paid to the competitive-failure of the composite cylindrical shells under combined loads. To bridge this research gap, a competitive failure analysis framework of degraded composite cylindrical shells exposed to combined axial compression and external pressure loads was developed, considering the nonlinear buckling-failure interacting curve approach for buckling-failure analysis and the Tsai-Wu failure criterion for stress-failure analysis. The material degradation model was adopted to modify the properties of the failed ply based on two degrading philosophies. The proposed framework agrees well with the published results. Extensive parametric studies are accomplished and presented to detect the failure mode of composites. For material parametric study, the variation of material properties does not significantly affect the shape of the normalized buckling-failure interacting curve, while it appreciably affects the behavior of the stress-failure interacting curve. Moreover, it is found that as the proportions of the longitudinal compressive strength to longitudinal modulus and transverse tensile strength to transverse modulus of composite materials increase, the tendency for buckling-failure increases; otherwise, stress-failure happens. For a geometric parametric study, decreasing the radius-to-thickness ratio leads to an increase in the shape of the buckling-failure interacting curve and the possibility of stress-failure.

The Competition Between Buckling and Stress Failure of Degraded Composite Cylindrical Shell under Combined Axial Compression and External Pressure Loads

Buckling and Stress-Competitive Failure Analyses of Composite Laminated Cylindrical Shell under Axial Compression and Torsional Loads

Experimental and Numerical Analyses on Buckling and Strength Failure of Composite Cylindrical Shells under Hydrostatic Pressure

The competition between buckling and overstress failure of composite laminated plates in compression and shear loads

Strain Response and Buckling Behavior of Composite Cylindrical Shells Subjected to External Pressure with One End Fixed and the Other under Free Boundary Conditions

Buckling Analysis of Moderately Thick Carbon Fiber Composite Cylindrical Shells under Hydrostatic Pressure

Study on the Stability and Strength of Composite Conical Shells Subjected to Hydrostatic Pressure

Experimental and Numerical Study on Bearing Failure of Countersunk Composite–composite and Composite–steel Joints

The Failure Mechanism of 3D C/C Composite under Compression-Shear Coupled Loads: an Experimental Study

Compressive Experiment and Damage Simulation of A Composite Structure with Ply Drop-Off

Performance Of Composite Cylindrical Shells Under Axial Compression Loads

Postbuckling and Damage Analysis of Composite Laminated Hollow Cylinder under Lateral Pressure

Buckling and Strength Failure for Unstiffened and Ring-Stiffened Composite Shells

Buckling and material failure analyses for ring-stiffened composite shells subjected to hydrostatic pressure

Experimental and numerical buckling analysis of carbon fiber composite cylindrical shells under external pressure

Compressive properties analysis of composite cylindrical shells

Influence of ply angle and length on buckling behavior of composite shells under hydrostatic pressure

A Post-Buckling Compressive Failure Analysis Framework for Composite Stiffened Panels Considering Intra-, Inter-Laminar Damage and Stiffener Debonding

Compressive Failure Analysis for Low Length-Width Ratio Composite Laminates with Embedded Delamination

Progressive Failure of Bolted Single-Lap Joints of Woven Fibre-Reinforced Composites

Comprehensive inter-fibre failure analysis and failure criteria comparison for composite materials using micromechanical modelling under biaxial loading