Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

A Friction Mechanism for Surface Texturing under Dry/mixed Lubrication Conditions Based on the Sublinear Dependence of Friction on Load

Friction Behavior of a Textured Surface against Several Materials under Dry and Lubricated Conditions

The Effect of Surface Texturing on Reducing the Friction and Wear of Steel under Lubricated Sliding Contact

Experimental study on the tribological performance of fractal-like textured surface under mixed lubrication conditions

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Friction-reduction Property of Round-pit Textured Surface under Reciprocating Motion

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

From Experimentation to Optimization: Surface Micro-Texturing for Low-Friction and Durable PTFE–Steel Interfaces Under Full Film Lubrication

A Design of Partial Textured Surface on Gear Washers for Reducing Friction and Wear under Low Speed and Heavy Load Conditions

A Pocket-Textured Surface for Improving the Tribological Properties of Point Contact under Starved Lubrication

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Experimental Study of Tribological Properties of Texture on Different Surfaces of Frictional Pairs

A Mixed Lubrication Model for Studying Tribological Behaviors of Surface Texturing

Experimental Study of the Effect of Surface Texturing on the Lubrication Performance in Point Contacts

Effect of Lubricant Infiltration into the Groove-Like Surface Texture on the Friction Response of the Textured Stainless-Steel Contact Surface

Development of low-cost deformation-based micro surface texturing system for friction reduction

Synergistic Lubrication for Textured Surfaces Using Polar and Nonpolar Lubricants

Anti-friction mechanism of sinusoidal texture with various intervals: the synergistic effect of dynamic pressure and tribofilm

Effects of Single- and Multi-Shape Laser-Textured Surfaces on Tribological Properties under Dry Friction

Surface Texturing for Low Friction Mechanical Components