Abstract:Background: Trans- inferior alveolar nerve (IAN) implantation technique was wildly used while the potential appropriate angle range in which the residual alveolar bone can bear the stress without absorption are currently unclear. This study aimed to evaluate the stress distribution pattern of the interface between bone and implant by finite element analysis (FEA) to determine the appropriate range of the implant tilt angle. Methods: Cone beam computed tomography (CBCT) images of 120 patients with missing mandibular second molars and vertical bone height < 9 mm in the edentulous area were selected. The distances from the mandibular nerve canal to the buccal cortex, the lingual cortex and the alveolar ridge crest were measured by using a combination of software. The angular ranges of the buccal-lingual inclination of simulated trans-IAN implants were measured and three-dimensional finite element models were constructed in the mandibular second molar area according to the differences of the inclination angles. A vertical load (200N) was then applied to analyze the biomechanical conditions of the implant-bone interface during median occlusion. Results: The distance at the second molar from the nerve canal to the buccal cortex, lingual cortex and alveolar crest were 6.861 ± 1.194 mm, 2.843 ± 0.933 mm and 7.944 ± 0.77 mm. Trans-IAN implantation was feasible in 73.33% of patients. The minimum angle and maximum angles of the buccal-lingual inclination of the simulated implant were 19.135 ± 6.721° and 39.282 ± 6.581°. When a vertical static load of 200N was applied, the tensile stress in cortical bone gradually increased with the increase of the implant tilt angle. When the inclination angle reached 30°, the tensile stress (105.9 MPa) exceeded the yield strength (104 MPa) of cortical bone. Compared with the conventional implants, the stress peak value of the vertical ultra-short implant in cortical bone was greater than the stress peak value of the conventional implants at 10°(79.81 MPa) and 20°(82.83 MPa) and was smaller than the stress of the implant at 30°(105.9 MPa) and 40°(107.8 MPa). Therefore, when the bone mass allows, conventional-length implants should be selected whenever possible, and an operative range of the trans-IAN implantation in the mandibular second molar could be retained with an inclination angle of < 30°. Conclusions: The mandibular nerve canal at the mandibular second molar was obviously biased to the lingual side, which ensured sufficient bone mass at the buccal side. In most patients with severe mandibular atrophy, it was possible to maintain a safe distance from the nerve canal with conventional-length implants via the trans-IAN implantation technique.

Morphological and quantitative study of the inferior alveolar nerve canal in hemifacial microsomia

Course of the Mandibular Canal in Hemifacial Microsomia: a Retrospective Computed Tomography Study.

Three-dimensional Analysis of Cranial Base Morphology in Patients with Hemifacial Microsomia.

Quantitative structural analysis of hemifacial microsomia mandibles in different age groups

Three-Dimensional Measurement of Maxillary Involvement in Hemifacial Microsomia in Children

Three-Dimensional Morphology and Configuration Analyses of the Craniovertebral Junction in Children With Hemifacial Microsomia

Classification of Hemifacial Microsomia Based on Bone Volume Ratio of the Healthy and Affected Sides of the Mandible: A Retrospective Self-control Experiment

Identifying the Anatomical Variations of the Inferior Alveolar Nerve with Magnetic Resonance Imaging

Discrepancy in Mandibular Medullary Cavity on Different Sides: More Hints Towards Understanding Hemifacial Microsomia

Assessment of Anatomical Location and Variation of Mandibular Foramen Using Cone-Beam Computed Tomography: A Cross-Sectional Study

The Etiology, Clinical Features, and Treatment Options of Hemifacial Microsomia

The study of mandibular alveolar nerve canal by cone-beam computed tomography

S7B-06 SESSION 7B: HFM ROBIN - PART II QUANTITATIVE ANALYSIS OF MASSETER MUSCLES IN PATIENTS WITH HEMIFACIAL MICROSOMIA

Examination of the masseter muscle in patients with hemifacial microsomia using high-frequency ultrasound and shear wave elastography

Endoscopic Visualization of the Inferior Alveolar Nerve Associated with Somatosensory Changes after Impacted Mandibular Third Molar Extraction.

Evaluation of the Linear Relationship of the Inferior Alveolar Nerve Canal to the Lateral Cortex and the Alveolar Crest in the Posterior Mandible: A Computed Tomographic Study

Detection and Characterization of the Accessory Mental Foramen Using Cone-Beam Computed Tomography

Do anatomical variations of the mandibular canal pose an increased risk of inferior alveolar nerve injury after third molar removal?

Inclination of mandibular incisors and symphysis in severe skeletal class III malocclusion

Lower Central Incisors Location of Severe Skeletal Class Ⅲ Malocclusion

Finite element analysis of the angle range in trans-inferior alveolar nerve implantation at the mandibular second molar