Abstract:Pure copper is widely used in motor windings, heat exchangers and aerospace engines because of its high electrical and thermal conductivity. High-strength laser powder bed fusion (HS-LPBF) not only allows rapid production of components with complex geometry and high spatial resolution, but also offers various advantages such as small focal spot diameter, fine powder, and small layer thickness, providing advantages for forming complex structural parts in fields such as engines and heat exchangers. A single factor single layer experiment was performed by varying the hatch spacing (H), and the range of hatch spacing was determined according to the overlap rate. The degree of influence of process parameters on the relative density of pure copper specimens was analyzed using an orthogonal experiment, and a comparative study of the phase composition, microstructure and mechanical properties of pure copper specimens was carried out by varying the laser power. The characteristics of pure copper formed by HS-LPBF were analyzed. In addition, the effect of heat treatment on the microstructure and mechanical properties of pure copper specimens was investigated, and the fracture morphology of the specimens was observed comparatively. The results show that the HS-LPBF technique can effectively increase the energy density and improve the specific surface area of the powder and the laser absorptivity due to its small focal spot diameter, fine powder and layer thickness, thus reducing the minimum energy required to melt pure copper powder. The optimum process parameters were obtained by orthogonal experiment with a relative density of 98.1 % of the specimen. The highest hardness, ultimate tensile strength and elongation were obtained at a laser power of 260 W with 84 HV, 320 MPa and 17.8 %, respectively. This ultimate tensile strength is 18 % higher than the highest ultimate tensile strength that has been reported so far. In addition, the average grain size of the optimal specimens was 3.6 μm. Mechanical properties such as hardness, tensile strength and elongation of pure copper parts can be significantly improved by precisely controlling the process parameters, in particular laser power and hatch spacing.

Manufacturing of High Strength and High Conductivity Copper with Laser Powder Bed Fusion

Fabrication of Copper Alloys as Conductive Materials via Laser Beam Powder Bed Fusion

Anisotropic material properties of pure copper with fine-grained microstructure fabricated by laser powder bed fusion process

Additive manufacturing of high strength copper alloy with heterogeneous grain structure through laser powder bed fusion

Enhanced electrical and mechanical properties of additively manufactured pure copper with green laser

High-strength and High-Conductivity Additively Manufactured Cu-O Alloy Enabled by Cellular Microstructure

Intentional Oxidation and Laser Remelting of Highly Reflective Pure Cu for Its High‐Quality Additive Manufacturing

Molten pool structure and temperature flow behavior of green-laser powder bed fusion pure copper

Additive manufacturing of micro‐architected copper based on an ion‐exchangeable hydrogel

Additive manufacturing of micro-architected copper based on an ion-exchangeable hydrogel

Fabrication of Cu-CNT Composite and Cu Using Laser Powder Bed Fusion Additive Manufacturing

Laser powder bed fusion of copper matrix iron particle reinforced nanocomposite with high strength and high conductivity

Additive Manufacturing of Electrically Conductive Multi-Layered Nanocopper in an Air Environment

High-precision laser powder bed fusion processing of pure copper

Laser powder bed fusion of electrically/thermally conductive component by developing inert Cr 2 O 3 -coated Cu powder

Mechanism of Simultaneous Improvement of Mechanical Performance and Conductivity of TiC/Cu Composites Prepared by Laser Powder Bed Fusion

High Reflectivity and Thermal Conductivity Ag–Cu Multi-Material Structures Fabricated via Laser Powder Bed Fusion: Formation Mechanisms, Interfacial Characteristics, and Molten Pool Behavior

Microstructures and mechanical properties of pure copper manufactured by high-strength laser powder bed fusion

High conductive copper alloys for additive manufacturing

Progress in laser powder bed fusion of pure copper/copper alloy highly reflective metal materials

Laser Powder Bed Fusion of Copper-Tungsten Powders Manufactured by Milling or Co-Injection Atomization Process