Abstract:Track structures are apt to generate degradation under repeated loading of train traffic. Avariation of support stiffness is one of the main degradations, such as unsupported sleepers and the transition position from embankment to a bridge, which occurred frequently. The service performance of track will decline including the comfort index of passengers and the safety of train in these areas. In order to understand the control standard of track stiffness variation, various models have been used to analyze the amplification of dynamic responses of track by researchers. The coupling effect of train and track structure was considered unnegligible in some researches. In this paper, an updated numerical model is developed based on track dynamic theory, in which the CA mortar and concrete base are both taken into consideration. The results were compared with the finite element model ( FEM) results based on ABAQUS software, in which the train loads are assumed as a series of constant loads. From the comparison, the influence of train-track interaction was presented. When the track has no irregularity or degradation, the wheel-rail contact loads are nearly constant, and the dynamic responses of track structure are the same in these two models. But if there are track stiffness variations,the results in train-track interaction model are larger than that in FEM,which means that the train-track interaction has an intensive effect. Besides the differences of track responses, the FEM cannot reveal the variation of contact forces and train responses, which are also essential to summarize the control standard of track degradation. At last, based on the train-track interaction model, various conditions of track stiffness variation are analyzed and discussed.

Gradient Descent Based Restoration Method of Track Irregularity in Asymmetric Chord Reference Method

An Automated System for Position Monitoring and Correction of Chord-Based Rail Corrugation Measuring Points

Vision-Based Position Deviation Measurement of Rail Corrugation Chord Measuring Points under Bi-Linear Laser Assistance

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Investigation of a dynamic chord method and its application on track irregularity evaluation and track maintenance

Acquiring the High-Precision Spectrum of Track Irregularity by Integrating Inclination in Chord Methods: Mathematics, Simulation, and a Case Study

Experimental and numerical investigations of asymmetric chord-reference system regarding track geometry measurement

Experimental measurement of track irregularities in EMS maglev systems using the mid-chord offset method and inverse filtering technology

Identification method of cyclic top defects in track geometry measurements in its early stage

Millimeter Scale Track Irregularity Surveying Based on ZUPT-Aided INS with Sub-Decimeter Scale Landmarks

Railway Track Irregularity Measuring by GNSS/INS Integration: Chen et al.: Railway Track Irregularity by GNSS/INS

Vertical Track Irregularity Caused by Subgrade Settlement and Its Design Criteria for High-speed Railway

Railway track quality assessment method based on mechanism modeling

Quantitative Detection of Vertical Track Irregularities under Non-Stationary Conditions with Variable Vehicle Speed

Design of railway transition zones: a novel energy-based criterion

A model-based approach for joint estimation of track irregularities and track support modulus from trackside measurements in railway turnouts

Measurement and analysis of the longitudinal level irregularity of the track beam in monorail tour-transit systems

A smoothness control method for kilometer‐span railway bridges with analysis of track characteristics

Identification of track irregularities with the multi-sensor acceleration measurements of vehicle dynamic responses

Degradation of railway track geometry – Correlation between track stiffness gradient and differential settlement