Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A 1-1.7 GHz Cryogenic Fractional-N CP-PLL for Quantum Computing Applications.

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A 400uw 3.6Ghz-4.6Ghz Low Power Cryogenic CP-PLL with Transformer-Based VCO in 28nm Bulk CMOS

A 0.8 V Low Power Low Phase-Noise Pll

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A Low Phase Noise V-Band 40 Nm Cmos Phase Locked Loop For Wireless Communication

Optimized System Design for Fully Integrated Fractional-N Pll

INVITED PAPER: A 4.5-5.4GHz Digital Bang-Bang PLL for Cryogenic Applications.

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

A low-noise, 0.05–17.8-GHz fractional-N phase-locked loop with two parallel synchronized dual-core voltage-controlled oscillators

A 56-GHz Fractional-N PLL With 110-fs Jitter

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

A 1.5–2.56-Ghz TDC-Assisted Fast-Locking Wideband Fractional-N CPPLL with Phase Noise of $-$ 138 Dbc/hz at 1-Mhz Offset Frequency

A 37.2-Fs, -254.6-db FoM, 47.9-to-56.4 GHz PLL Using Tightly Coupled Dual-core VCO with Implicit 4th Harmonic Extraction Technique

A Ku-Band FSK Modulated Fractional-N PLL With Fine Frequency Resolution

A 29.5 to 31.7 GHz PLL in 65 Nm CMOS Technology

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

A 68.1-to-73.8ghz E-band Low Phase Noise QPLL with Amplifier Feedback QVCO in 65-Nm CMOS

A Sub Mw Low Flicker Noise Cryo-CMOS QVCO for Quantum Computing Application

A 21.8-41.6GHz Fractional-N Sub-Sampling PLL with Dividerless Unequal-REF-Delay Frequency-Locked Loop Achieving -246.9dB FoMj and -270.3dB FoMj,N