Abstract:A sensing system for simultaneously measuring strain and temperature is proposed by employing a polarimetric multi-longitudinal mode fiber laser sensor and beat frequency demodulation device. The proposed fiber laser is built with two fiber Bragg gratings and a piece of Erbium-doped-fiber, which act as cavity reflector and gain medium, respectively. Owing to the intrinsic birefringence of fiber, two orthogonal polarization modes experience slight splitting, thus many longitudinal mode beat signals and polarization mode beat signals are generated in the laser cavity. Strain and temperature can be measured simultaneously by monitoring the frequency shift of longitudinal mode beat signal and polarization mode beat signal due to their different responses to strain and temperature. The selection of beat frequency signal pair for improving the laser sensitivity has also been analyzed and investigated experimentally. In addition, the repeatability and stability performances of the proposed laser were also investigated. The proposed sensing system just uses one polarimetric fiber laser sensor and one beat frequency demodulation equipment, and it shows distinctive advantages of simple structure, portability, high sensitivity, and low cost due to the avoidance of expensive optical detection device for wavelength monitoring.

Twin-Core Fiber-Based Erbium-Doped Fiber Laser Sensor for Decoupling Measurement of Temperature and Strain

High-Resolution Strain/Temperature Sensing System Based on A High-Finesse Fiber Cavity and Time-Domain Wavelength Demodulation

Strain and Temperature Discrimination Using Concatenated Fiber Grating Lasers

Simultaneous Strain and Temperature Fiber Grating Laser Sensor Based on Radio-Frequency Measurement

Demodulation of a Fiber Bragg Grating Sensor System Based on a Linear Cavity Multi-Wavelength Fiber Laser

Strain-insensitive temperature sensing with a dual polarization fiber grating laser

Polarimetric Multilongitudinal Mode Fiber Laser for Simultaneous Measurement of Strain and Temperature

Axial Strain and Temperature Sensing Characteristics of the Single–coreless–single Mode Fiber Structure-Based Fiber Ring Laser

Bragg grating tuned fiber laser system for measurement of wider range temperature and strain

Demodulation Of A Fiber Bragg Grating Strain Sensor By A Multi-Wavelength Fiber Laser

Cascaded Fabry-Perot Interferometer-Regenerated Fiber Bragg Grating Structure for Temperature-Strain Measurement under Extreme Temperature Conditions.

Optical Fiber Sensor with Double Tubes for Accurate Strain and Temperature Measurement under High Temperature Up to 1000 °C

Fiber Bragg grating strain sensor based on fiber laser

Multilongitudinal Mode Fiber Laser for Strain Measurement

Temperature And Strain Dual-Parameter Heterogeneous Fiber Bragg Grating Sensor Made By Femtosecond Laser

In-fiber Torsion and Temperature Measurement Based on Femtosecond-Laser-inscribed Eccentric Fiber Bragg Grating

Dual-Wavelength Fbg Inscribed by Femtosecond Laser for Simultaneous Measurement of High Temperature and Strain

An Active Strain Sensing System Based on Single‐longitudinal‐mode Distributed Bragg Reflector Fiber Laser and Its Applications in the Measurement of Erbium‐doped Fiber Birefringence

Short Cavity Single Frequency Fiber Laser for In-Situ Sensing Applications over A Wide Temperature Range

Temperature Sensor Based on Er-Doped Cascaded-Peanut Taper Structure In-Line Interferometer in Fiber Ring Laser

Research On Fiber Laser Sensor Based On Multimode Interference Effect With No-Core Fiber