Abstract:A series of hydrocracking catalysts based on mesoporous molecular sieves of MCM-41 and SBA-15 with different silica to alumina ratios was prepared. Nickel and molybdenum were used as active metals to impregnate the extrudates prepared by using molecular sieves. The catalysts were characterized for physical and chemical properties and evaluated for the hydrocraking of desulfurised vacuum gas oil. The conversion of DS-VGO was lower as compared to that of the catalyst based on USY zeolite. However, the gas yield was lower in case of mesoporous materials based catalysts. Introduction Zeolites are widely used as catalysts in petroleum refining and for the production of petrochemicals and fine chemicals. Recently, the breakthrough discovery of the M41S family mesoporous materials [1,2] exemplified by the MCM-41 bearing hexagonal-close-packed channels. Despite the excellent structural properties, the hydrothermal stability of MCM-41 and MCM-41-like mesoporous materials was reported as lower than their counter part zeolites. Recently, a new kind of mesoporous silica, SBA-15, has been synthesized with poly (alkylene oxide) triblock copolymers such as poly (ethylene oxide)-poly (propylene oxide)poly (ethylene oxide) (PEO-PPO-PEO) [3]. Beside its uniform and large pore size channels (4.6-30 nm), SBA-15 possesses thick walls (3.1-6.4 nm). Therefore, it has much higher hydrothermal stability than MCM-41 [3]. Owing to their extremely large surface area (generally exceeding 1000 mg) and ultra large pore size these mesoporous materials have attracted great practical and academic interest as acid-catalyzed reactions of large molecules such as hydroprocessing of residual oil [4-5]. In this study, the preparation of MCM-41 and SBA-15 with Si/Al 10, 20 and hydrocracking catalysts based on these mesoporous materials along with USY zeolite are presented. Commercial USY zeolite used in this study also has mesopores in it. Nickel and molybdenum are impregnated as active metals. Mesoporous materials and hydrocracking catalysts prepared were characterized by XRD, surface are, pore volume, pore-size distribution, particle size measurement, and acidity measurement by FTIR and ammonia TPD. The side crushing strength of the extrudates with alumina binder was also measured by crushing strength tester. The catalysts were evaluated for hydrocracking of desulfurized vacuum gas oil (DS-VGO). The hydrocracking activity was measured by GC-SIMDIST method and sulfur and nitrogen contents of the product were measured by elemental analyzer.

Mesoporous Materials from Zeolite Seeds As Supports for Nickel Tungsten Sulfide Active Phases

Mesoporous Materials from Zeolite Seeds As Supports for Nickel–tungsten Sulfide Active Phasespart 2. Catalytic Properties for Deep Hydrodesulfurization Reactions

Nanometer β Zeolite Made from Mesoporous Zeolite and Its Hydrocracking Performance

Hierarchical TS-1 zeolite loaded with NiMo catalysts: Preparation and performance in hydrodesulfurization

In Situ Synthesis of Nb-modified AFI Topology Molecular Sieve and Its Modulation on the Formantion of High-Efficiency Catalyst for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

ZSM-5@MCM-41 core–shell composite with tunable shell thickness for n -heptane catalytic cracking reaction

Nickel-embedded zeolite subcrystal catalyst: Rapid enhancement of activity and metal impurity resistance in hydrodesulfurization of 4,6-dimethyldibenzothiophene

Impact of varied zeolite materials on nickel catalysts in CO 2 methanation

HZSM-5/MCM-41 composite molecular sieves for the catalytic cracking of endothermic hydrocarbon fuels: nano-ZSM-5 zeolites as the source

Synthesis of CuO–ZnO–Al2O3 @ SAPO-34 Core@shell Structured Catalyst by Intermediate Layer Method

Catalytic Cracking of Supercritical N-Dodecane over Meso-Hzsm-5@al-mcm-41 Zeolites

Synthesis and Catalytic Evaluation of Mesoporous Molecular Sieve Supported Hydrocracking Catalysts

Mesoporous Aluminosilicate Catalysts for the Selective Isomerization of n-Hexane: The Roles of Surface Acidity and Platinum Metal.

Synthesis of mesoporous molecular sieves and their application as supports for catalysts in F-T synthesis

Synergetic Regulation of the Microstructure and Acidity of HZSM-5/MCM-41 for Efficient Catalytic Cracking of n-Decane

Seeds induced Beta zeolite synthesis with low SDA for n-heptane catalytic cracking reaction

Tuning metal-support interactions in nickel-zeolite catalysts leads to enhanced stability during dry reforming of methane

Hierarchically porous Beta/SBA-16 with different silica-alumina ratios and the hydrodesulfurization performances of DBT and 4,6-DMDBT

Highly Dispersed Nickel Particles Encapsulated in Multi‐hollow Silicalite‐1 Single Crystal Nanoboxes: Effects of Siliceous Deposits and Phosphorous Species on the Catalytic Performances

The mesoporous silicate-alumina composites application as supports for bifunctional sulfide catalysts for n-hexadecane hydroconversion

Antisintering and High-Activity Ni Catalyst Supported on Mesoporous Silica Incorporated by Ce/Zr for CO Methanation