Effect of Partial Pressure of Air in HFC134a/N_2/Air Atmosphere on Protection of Magnesium Alloy in a Sealed Smelting Furnace

Xiong Shou-mei

2007-01-01

Abstract:The mixed gas of 0.01 %(volume fraction)HFC134a/N2/air was fed into a sealed smelting furnace once,for the protection of AZ91D magnesium alloy subjected to smelting in the furnace.The influences of the air partial pressure in the mixed gas,stirring of the smelted Mg alloy,and holding time of smelting on the protection outcome of the Mg alloy smelted at 760℃ were investigated,while the corrosiveness of the mixed protective gas to the inner wall of the smelting crucible was examined.Moreover,the morphology,thickness,and composition of the surface film of the smelted Mg alloy were analyzed.The results showed that at an air partial pressure of 8.0 kPa the mixed atmosphere had good protection to the AZ91D alloy smelted at 760℃,for a holding time of 10 h,and the protection was not affected by surface agitation.With the increase of the air partial pressure from 2.3 kPa to 80.0 kPa,the smoothness of the smelted Mg alloy decreased,the content(atom fraction)of 0 in the surface of the smelted Mg alloy Journal of Materials Protection increased from 11.98% to 26.62% and that of C decreased from 0.98% to 0,accompanied by the increase in the thickness of the film from 1.1 μm to 1.7 μm and the transformation from the absence of red-rust corrosion on the inner wall of the furnace to large flakelike peeling of iron oxide.When the air partial pressure rose to 80.0 kPa,the corresponding smelted Mg alloy was characterized by twolayer structure,and the top layer was dominated by loose reticulation-like structure.Therefore,it was suggested to control the air partial pressure of the mixed 0.01 % HFC134a/N2/air atmosphere in the sealed smelting furnace at a rationally low level so as to get rid of severe oxidation of the Mg alloy.