Abstract:China is a country that suffers a lot from the earthquake disaster. The major reason for the human death and property losses in earthquake is the collapse of the tall buildings. Hence, correct simulation for the failure modes and accurate prediction for the collapse of the tall buildings under earthquake disaster is very useful for studying the safety of buildings and evaluating losses during earthquakes[1]. However, a lot of simplifications must be carried out in the existing simulations to overcome the numerical problems because the grave nonlinearity exists when collapse happens. This may lead to the results away from a real phenomenon. In this study, a fiber model for reinforced concrete (RC) structures (referred as THUFIBER) is developed, which is based on the general-purpose finite element package of MSC.MARC that carries significant capacity of solving nonlinear problems. In this model, the concrete and the reinforcement inside the structural elements are modeled respectively with different fibers as shown in figure 1 so that the cyclic behavior of material can be properly simulated. Pushover and dynamic time-history analysis for a RC frame tall building are carried out to illustrate the capacity of the proposed model. And dynamic time-history analysis is emphasized in this paper to discuss the collapse modes of the structure. The results show that THUFIBER can simulate the collapse and failure process of the structure under the dynamic loads such as complicated seismic loads, including the softening and fracture behaviors of structural elements, and further the program shows good convergence in the non-linear cases. So THUFIBER has a strong and promising ability for nonlinear analysis including collapse numerical simulation. Figure 1 Section dicretization of the fiber model Figure 2 Simulation for the Collapse of the frame

Collapse Simulation of RC Frame under Earthquakes. II: Verification Studies - Collapse of Cypress Viaduct

COLLAPSE SIMULATION AND ANALYSIS OF CYPRESS VIADUCT DURING LOMA PRIETA EARTHQUAKE

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Collapse tests of RC frame with sudden middle column removal

Experimental research on a large scale RC frame model subjected to sudden corner column removal

Experimental Investigation on Performance of Cantilever CFRP-wrapped Circular RC Columns under Lateral Low-Velocity Impact

Experimental Study and Numerical Model Calibration for Earthquake-Induced Collapse of Rc Frames with Emphasis on Key Columns, Joints, and the Overall Structure

Simulation for the Collapse of RC Frame Tall Buildings under Earthquake Disaster

Lessons from the Collapse of Typical RC Frames in Xuankou School During the Great Wenchuan Earthquake

Collapse Simulation of RC High-Rise Building Induced by Extreme Earthquakes

Numerical Simulation for the Progressive Collapse of Concrete Building due to Earthquake

Collapse Simulation of Reinforced Concrete Moment Frames Considering Impact Actions among Blocks

Collapse simulation of reinforced concrete high-rise building induced by extreme earthquakes

Shaking Table Test on the Collapse Process of A Three-Story Reinforced Concrete Frame Structure

Numerical simulation for pseudo-static test of RC frame structure based on the fiber model

Modeling of non-ductile RC structure under near-fault ground motions: A nonlinear finite element analysis

Study on Bridge Collapse Resulting from Fault Rupture

Numerical failure analysis of a continuous reinforced concrete bridge under strong earthquakes using multi-scale models

Experimental studies on a novel structural detailing of RC frames to resist earthquake and progressive collapse

Application of Fiber Model for Progressive Collapse Analysis of Reinforced Concrete Frames *

Numerical Modelling of the Progressive Collapse of Reinforced Concrete Frames with Different Lateral Restraints