Abstract:Aiming at the fast protection requirements of electrical ships LVDC distribution system, this paper studies a topology of unidirectional vacuum hybrid circuit breaker. The hybrid circuit breaker is an improved current injection LVDC breaker based on precharged capacitor, which improves the dielectric recovery capability of vacuum interrupter after artificial current zero by using a freewheel diode. A synthetic test platform is built to study the dielectric strength recovery characteristics of a 45 mm diameter CuCr50 butt contact vacuum interrupter (driven by Thomson coil actuator, average opening speed of about 3 m/s)under high current(about 20 kA) and small gap(about 1 mm). The experimental results indicate that the dielectric strength of the contact can recover at a very fast speed within the arc time of 100 mu s; when the arc time is increased to 320 mu s, the dielectric strength of the contact cannot recover for a long time. Therefore, the design principle of the circuit breaker is obtained: within the arc time of 100 mu s, by increasing the arc time can increase the contact distance, so the transient interruption voltage tolerance margin of the circuit breaker can be improved. Based on the results of the test, this paper also proposes a calculation method of forced commutation circuit parameters, which is verified by the simulation. The research results show that the DC circuit breaker can realise the rapid breaking of 20 kA fault current within 2 ms, and has a good application prospect in the LVDC distribution system.

Fault Current Limiter Based on Current Commutation at Power Frequency Zero and Simulation of 40.5 Kv Fast Vacuum Switch

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

Simulation Study of New Solid-State Fault Current Limiter

Hybrid Multifunctional Saturated-core Fault Current Limiter

A Fast LVDC Vacuum Hybrid Circuit Breaker: Dielectric Recovery and Design Consideration

Simulation Study of Series Resonance Type Fault Current Limiter

Study on Mathematic Model and Model Simulation of the Three Phase Solid State Fault Current Limiter

Design Of A Novel Bridge-Type Fcl And Its Application In Upfc

A Novel Six-Leg Three-Phase Fault Current Limiter

Two-Stage DC Fault Current Limiter Combining Hybrid Magnetic Materials and Active Flux Coupling Coils

Design and Test of UPFC-FCL Prototype.

Research of fault-current limiter for three-phase four-wire power system

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

A Novel Fast Energy Storage Fault Current Limiter Topology for High-Voltage Direct Current Transmission System

A Dual-Stage Solid-State Fault-Current Limiter for Flexible DC Distribution Networks

Development of a Hybrid Fault Current Limiter Using Liquid Metal for Large Capacity MVdc Power Systems

UPFC with fault current limiting and capacitor voltage limiting

Experimental Study on Fast Isolating Switch with Vacuum Multi-breaks

Dc Capacitor Parameter Design Of Unified Power Flow Controller With Fault Current Limiting

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

Topology Modeling and Design of a Novel Magnetic Coupling Fault Current Limiter for VSC DC Grids