Abstract:Residual stress constitutes an integral part of the total stress acting on any component in service. It is imperative to determine residual stress to estimate the life of critical engineering components, especially those that are welded. The stresses caused by non-uniform temperature distribution due to welding and the effect of these multiaxial stresses upon service performance are discussed. A controlled thermal severity test (CTS) was performed on mild steel plates bolted together, with anchor welds deposited on opposite sides. After cooling, bithermal and trithermal test welds were deposited one after the other. Varying welding stresses were deliberately introduced by using different thicknesses of both plates to change the thermal severity numbers (TSN). The main experimental technique used here to determine the magnitude and nature of residual stress is based on X-ray diffraction (XRD). It was utilised to develop and standardise other techniques. The XRD method is based on the peak shiftin the diffraction profile due to the presence of stress using a sin2 ψ method. The peak shift is determined by orienting the sample at different angles ± ψ to the incident X-ray beam. The semidestructive technique of hole drilling and use of a strain gauge was also employed to determine residual stress in CTS specimens. The magnitude, nature, and direction of principal stresses were determined by relieving stresses through incremental blind hole drilling and measuring strain values at each step. The surface displacements arising due to hole drilling can also be determined by laser holography. A sandwich holography technique was developed to avoid unwanted rigid body motions of samples due to hole drilling when relieving stresses. Stress values were obtained by measuring fringe displacement between two exposures of a sandwich hologram, due to hole drilling. Results on the change in residual stress values with TSN are discussed. The residual stress values determined by XRD and sandwich holography were found to be comparable, and stress values obtained by hole drilling/strain gauge measurement were higher than these values. The reasons are discussed.

BASIC KNOWLEDGE OF RESIDUAL STRESS DETERMINATION——LECTURE No.6 RELATIONSHIP BETWEEN RESIDUAL STRESS WITH ESC

THE-STATE-OF-THE-ART OF THE STUDY ON RESIDUAL STRESS MEASUREMENT BY X-RAY ANALYSIS

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Residual Stress in Engineering Materials: A Review

Recent progress of residual stress measurement methods: A review

An approach for obtaining surface residual stress based on indentation test and strain measurement

Effect of residual tensile stress on stress corrosion behavior of the base metal of x80 uoe pipe

Development and comparison of residual stress measurement on welds by various methods

COMPUTATION OF RESIDUAL STRESS INTENSITY FACTORS INDUCED BY SINGLE OVERLOAD DURING FATIGUE CRACK GROWTH

Recent Progress in Residual Stress Measurement Techniques

Fatigue life prediction of 316L stainless steel weld joint including the role of residual stress and its evolution: Experimental and modelling

Welding residual stress behavior under mechanical loading

A Study of Residual Stress in the Repair Weld of Stainless Steel Clad Plate by Neutron Diffraction Measurement and Finite Element Method

A Simple Engineering Approach in the Prediction of the Effect of Stress Ratio on Fatigue Threshold

Review on the Prediction of Residual Stress in Welded Steel Components

Residual Stress Determination of Cast Aluminium Benchmark Components Using Strain Relief Techniques

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

EXPERIMENTAL STUDY ON RESIDUAL STRESS OF AUSTENITIC STAINLESS STEEL 316 IN FABRICATED I-SECTIONS

Uncertainty quantification in residual stress affected fatigue crack growth life