Abstract:Type IV hydrogen storage cylinder is a rising high-pressure hydrogen storage equipment, which is composed of a polymer liner and a fully wrapped carbon fiber composite. It is found that local blisters occur on polymer liners after rapid depressurization tests during the research and development process. Some manufacturers choose to add adhesives at the liner-composite interface to avoid blisters. In order to study the effect of adhesives to the local blisters, two type IV cylinders have been manufactured and tested, in which one has adhesives at the interface and the other does not. The depressurization tests were conducted from around 70 MPa–2 MPa under various mass flow rates . Digital radiography (DR) and videoscope have been used to conduct post-test inspections. Finite element analysis (FEA) was performed to verify the effect of adhesives, as well as estimating the pressure differential at the interface based on test results. According to the results of the test and FEA results, the use of adhesives at the interface does not effectively prevent the occurrence of local blisters. However, it does serve to slow down the blister propagation though. The results also indicate that the mass flow rate plays a crucial role in affecting the size of the local blister. Furthermore, based on the test and FEA results, an estimation of the local pressure differential at the interface that causes local blister was made. During the post-test inspection, it was observed that the size of several blisters initially increased but eventually decreased over time. Additionally, adjacent blisters were observed to merge as a single larger blister after the hydrostatic test. These results provide valuable insights into the formation and behavior of local blisters, which can inform future research and practical applications in relevant fields.

Blister Damage Evolution in Plastic Liner of Type IV Hydrogen Storage Vessel Studied by Fracture Mechanics

Study on the manufacturing and failure modes of type iv high-pressure hydrogen vessel liner

Experimental Analysis on Residual Performance of Used 70 MPa Type IV Composite Pressure Vessels

DEVELOPMENT OF STRIP WINDING HIGH PRESSURE HYDROGEN STORAGE VESSEL WITH LOW STRESS INNER LINER

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Numerical Simulation on Hydrogen Induced Cracking Behavior of 4130X Hydrogen Storage Vessel with Defect

Study of blister phenomena on polymer liner of type IV hydrogen storage cylinders

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Damage Assessment of Liquid Nitrogen Filling on Type III Cylinder in Cryo-Compressed Hydrogen Storage Cylinder

Dynamic Response Characteristics and Damage Modes of Multifunctional Layered Hydrogen Storage Vessels under Impact Loads

Dynamic Response and Vibration Modes of Multi-Layer Wound Cylindrical Shell for Hydrogen Storage under External Blast Loading

Experimental Investigation on the Deformation and Damage of Steel Ribbon Wound Vessel for Hydrogen Storage under External Impact and Blast Loading

Research on the Influence of the Liner Crack Size and Location on Fatigue Life of 70mpa Type III Cylinder

Review on Hydrogen-Induced Failure of Rubber O-Rings for High Pressure Hydrogen Storage Tanks

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Hydrogen Permeation Behavior of the Liner of Type IV Hydrogen Storage Cylinders under Different Pressures

Effect of inside diameter on design fatigue life of stationary hydrogen storage vessel based on fracture mechanics

Micromechanics-based Burst Failure Analysis of Composite Vessel Used for Hydrogen Storage

Review of Decompression Damage of the Polymer Liner of the Type IV Hydrogen Storage Tank

Study of the Failure Mechanism of a High-Density Polyethylene Liner in a Type IV High-Pressure Storage Tank

Design Fatigue Life Evaluation of High-Pressure Hydrogen Storage Vessels Based on Fracture Mechanics