Abstract:In an atomic vapor laser isotope separation process, the required isotope atoms are ionized selectively by a pulsed laser with a specific narrow line width, and then the produced isotope ions are extracted to the collected plates under an externally applied electromagnetic field. In the whole ion separation process, the ion extraction sub-process is one of the most important physical processes. Previous studies have shown that the key parameters of the laser-induced plasma, e.g., the initial electron number density and temperature, have a significant influence on the ion extraction features. In an actual isotope separation process, a specifically designed laser is necessary to produce the required isotope ions, which, however, leads the whole facility to have a very complicated structure, high capital cost, and especially, very narrow window of the key plasma parameters. These will, to some extent, limit a more in-depth investigation of the influences of the key plasma parameters on the ion extraction characteristics. In this paper, an ion extraction platform (ion extraction simulation experimental platform-2015, IEX-2015) is developed on the basis of a gas discharge plasma jet driven by a kilo-hertz high-voltage power supply. And an argon plasma "collisional-radiative" model is established to measure the electron temperature and number density in the plasma jet region. The experimental results show that the power input and driving frequency of the power supply and the argon mass flow rate can all affect the electron temperature and electron number density. The measured variation ranges of the electron number density and temperature are 10(9)-10(11) cm(-3) and 1.7-2.8 eV, respectively, under a chamber pressure on the order of 10(-2) Pa, which are close to the parameter levels in the actual ion extraction process. Subsequently, the preliminary ion extraction experiments are conducted under different extraction conditions including different externally applied voltages, different electrode distances and different plasma densities. The experimental results are also qualitatively consistent with those in an actual ion extraction process. The preceding preliminary experimental results show that it is feasible to conduct the ion extraction simulation study on IEX-2015. This is very helpful for systematically studying the ion extraction characteristics under different operating conditions in our future research.

Particle Simulations of Ion-Extraction Process from a Decaying Plasma Assisted by Radio-Frequency Plasma Heating

Non-equilibrium Transport of Charged Particles in a Wall-Confined Decaying Plasma under an Externally Applied Electric Field

Effects of Electron Temperature on the Ion Extraction Characteristics in a Decaying Plasma Confined Between Two Parallel Plates

Beam-assisted Extraction of Charged Particles from a Decaying Plasma

Theoretical Analyses on the One-Dimensional Charged Particle Transport in a Decaying Plasma under an Electrostatic Field

Numerical Studies on the Non-Equilibrium Transport of Charged Particles in a Confined Decaying Plasma: Effects of the Ion Rarefaction Waves

Ion heating in the PISCES-RF liquid-cooled high-power, steady-state, helicon plasma device

Experimental study on plasma characteristics in the extraction region of a high-power RF negative ion source based on electrostatic probe

Physical Characteristics of Ion Extraction Simulation System Based on Gas Discharge Plasma Jet

Ionization by bulk heating of electrons in capacitive radio frequency atmospheric pressure microplasmas

Electron Dynamics and Metastable Species Generation in Atmospheric Pressure Non-Equilibrium Plasmas Controlled by Dual LF–RF Frequency Discharges

Experimental Study on Ion Extraction Process by Electrostatic Field Between Two Parallel Plates with Adjustable Distance

Kinetic Simulation of He radio frequency capacitive coupled plasma

Study of Ion Extraction from Laser-Induced Air Plasma

Ionization and neutral gas heating efficiency in radio frequency electrothermal microthrusters: The role of driving frequency

Electron dynamics in planar radio frequency magnetron plasmas: II. Heating and energization mechanisms studied via a 2d3v particle-in-cell/Monte Carlo code

Analysis and Particle-in-cell Simulation on the Similarity Relation During an Ion Extraction Process

One-dimension Modeling on Parallel-plate Ion Extraction Process Based on Electron-equilibrium Fluid Model

Key Parameter Measurements of the Low-Pressure Gas Discharge Plasmas Used for Studying the Ion Extraction Process

Modeling of the charged particle transport process in a decaying plasma with a -type electrode configuration

3D simulations of the RF wave propagation and power coupling in cold magnetized plasma near an ICRF antenna