Abstract:Lithium–sulfur (Li–S) batteries are regarded as one of the most promising next-generation battery technologies owing to their ultrahigh energy density up to 2600 W h kg–1 and low cost. However, major challenges still remain in the application of Li–S batteries, such as shuttle effect and sluggish redox kinetics. Herein, it is demonstrated that phosphorus doping can not only significantly improve the polysulfide adsorption but also enhance the catalysis effects of metal–organic framework-derived CoS2 nanoboxes in Li–S batteries. Consequently, a modified separator integrated with P–CoS2 and carbon nanotubes effectively suppresses the polysulfide shuttle and propels the redox kinetics of polysulfides, thus promising higher specific discharge capacity, better rate, and stable cycle performance. Even under the high sulfur loading condition (4.8 mg cm–2), the areal discharge capacity of the cell with the functional separator can still remain at 4.5 mA h cm–2 after 100 cycles at 0.2 C. More importantly, this work may encourage more effort on anion doping for engineering the polar surface of transition-metal compounds to further mediate the interfacial redox chemistry between transition-metal compounds and polysulfides in Li–S batteries.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c00494?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c00494</a>.XRD patterns, SEM, TEM images of Co–MOF and CoS2; high-magnification XRD patterns of CoS2 and P-CoS2 in the 2θ range of 30–35°; EDS mapping images of CoS2 and P-CoS2; P 2p XPS spectrum of P-CoS2 after etching; SEM images from the front and the cross-section for the CNT-, CoS2/CNT-, and P-CoS2/CNT-modified separator; digital image of the P-CoS2/ separator and folding and unfolding test of the P-CoS2/ separator; permeation tests of the pristine Celgard, , CoS2/, and P-CoS2/ separators; CV curves of symmetric cells of CNTs with and without Li2S6 at 1 mV s–1; galvanostatic discharge/charge curves of P-CoS2/ at 2.0 C; galvanostatic discharge/charge curves and cycling performance of the P-CoS2 cathode without sulfur for the initial few cycles at 0.1 C; postmortem SEM images and EDS analysis of the lithium foil; postmortem SEM images and EDS analysis of CoS2 and P-CoS2 after 1.0 C cycles; and performance statistics of similar Li–S batteries in the literature (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c00494/suppl_file/am1c00494_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Correction to Highly Efficient Retention of Polysulfides in “Sea-Urchin”-like Carbon Nanotube/Nanopolyhedra Superstructures As Cathode Material for Ultralong-Life Lithium–Sulfur Batteries

Chloride‐Reinforced Carbon Nanofiber Host As Effective Polysulfide Traps in Lithium–Sulfur Batteries

Cathode Nanostructuring and Separator Modification for High-Performance Lithium-Sulfur Batteries

Multi‐Functional Layered WS2 Nanosheets for Enhancing the Performance of Lithium–Sulfur Batteries

Sub-nanometric Manganous Oxide Clusters in Nitrogen Doped Mesoporous Carbon Nanosheets for High-Performance Lithium–Sulfur Batteries

A Nacre‐Like Carbon Nanotube Sheet for High Performance Li‐Polysulfide Batteries with High Sulfur Loading

Advanced Li–S Batteries Enabled by a Biomimetic Polysulfide-Engulfing Net

Strong Lithium Polysulfide Chemisorption on Electroactive Sites of Nitrogen-Doped Carbon Enables High-Performance Lithium-Sulfur Battery Cathodes

Enhanced Adsorption of Polysulfides on Carbon Nanotubes/Boron Nitride Fibers for High-Performance Lithium-Sulfur Batteries

Synergistic Defect Engineering and Interface Stability of Activated Carbon Nanotubes Enabling Ultralong Lifespan All-Solid-State Lithium-Sulfur Batteries

Correction to Redox Catalysis Promoted Activation of Sulfur Redox Chemistry for Energy-Dense Flexible Solid-State Zn–S Battery

An Entangled Cobalt–Nitrogen–Carbon Nanotube Array Electrode with Synergetic Confinement and Electrocatalysis of Polysulfides for Stable Li–S Batteries

Ultrasmall Li 2 S-Carbon Nanotube Nanocomposites for High-Rate All-Solid-State Lithium–Sulfur Batteries

Ion Selective Covalent Organic Framework Enabling Enhanced Electrochemical Performance of Lithium–Sulfur Batteries

Phosphorus-Doped Metal–Organic Framework-Derived CoS 2 Nanoboxes with Improved Adsorption-Catalysis Effect for Li–S Batteries

Long-Life, High-Efficiency Lithium–Sulfur Battery from a Nanoassembled Cathode

3D Cotton-Pad-Like Hierarchically Porous Structure Stacked by Hexagonal Highly Graphitized Carbon Nanosheets as Sulfur Immobilizers for Li–S Batteries

Oxygen‐vacancy‐containing cerium oxide nanoparticle‐decorated nanonetwork‐structured carbon toward high‐performance lithium–sulfur batteries

Porous sulfurized poly(acrylonitrile) nanofiber as a long-life and high-capacity cathode for lithium–sulfur batteries

Atomic Layer Deposition of Single Atomic Cobalt as a Catalytic Interlayer for Lithium–Sulfur Batteries

CNTs@S Composite As Cathode for All-Solid-state Lithium-Sulfur Batteries with Ultralong Cycle Life