“Soft-Hard” Microstructure Evolution and Its Relevance to High Strength–plasticity and Low Plastic Anisotropy of Al–Mg Alloys Based on Ultra-Fast Heating

Weiying Wen,Yanjun Zhao,Yongjie Deng,Kaiwei Peng,Yafei Liu,Feng Wei
DOI: https://doi.org/10.1016/j.msea.2024.146154
2024-01-01
Abstract:The mechanical anisotropy caused by the apparent texture after large plastic deformation and deformation strengthening in metals has always been a contradiction. Here, 80 % cold-rolled Al-Mg alloy was annealed using the ultra-fast heating process (500 degrees C/s heating to 450 degrees C), leading to substructured grains with high geometrically necessary dislocations (4.12 x 10(14) m(-2)) and recrystallized grains with low geometrically necessary dislocations (0.78 x 10(14) m(-2)); each of these accounted for approximately 50 % of the grains. The alloy's strength was much higher than the corresponding conventional annealing one, while the ductility remained unchanged. In addition, the weaker transition texture components such as Brass, Z, R-Goss(ND), and Goss increased significantly due to the presence of many substructural grains. In contrast, the Cube texture decreased significantly, thus leading to a decrease in the texture intensity and, in turn, a significant reduction in the anisotropy. The excellent comprehensive properties are attributed to the microstructures with a mixture of "soft-hard" grains and multicomponent-low-intensity textures. The present study provides a new approach to fabricating Al-Mg alloys with high strength, high ductility, and a low anisotropy of the mechanical properties.
What problem does this paper attempt to address?