Abstract:The backflow power in dual-active bridge (DAB) converters can cause power circulation in the H-bridge instead of flowing to the load, which increases the power loss of switching devices and magnetic components and lowers the system's efficiency. Hence, a unified optimal modulation strategy (UOMS) is proposed in this article to reduce the backflow power and consequently improve the system efficiency. However, there is a conflict between minimizing the backflow power and achieving the zero-voltage-switching (ZVS) conditions of all the switching devices. Hence, a regulatory factor " gamma" is introduced into the control variables to minimize the backflow power on the premise of all ZVS conditions, and hence, comprehensively improve the system efficiency. Moreover, the regulatory factor " gamma" simplifies the calculation form of the control variables, which is easier to perform in the controller and can effectively shorten the computational time. According to the value ranges of the control variables (D-0, D-1, and D-2) in the proposed UOMS, 12 operating modes are classified and four effective modes are detailed. For the four effective modes, the optimal triple-phase shift (TPS), optimal primary-dual-phase shift (PDPS), and optimal secondary-dual-phase shift (SDPS) modulation strategies are derived and their switching relationships are revealed. With various transferred powers, the proposed UOMS combines the optimal TPS, PDPS, SDPS, and SPS modulation strategies and can realize smooth and seamless transition switching processes among them in the full operating range. Therefore, the DAB converter can always operate in the optimal states for the full operating range of both the "Buck Mode" (k > 1) and "Boost Mode" (k < 1). Finally, experimental results verify the correctness of the theoretical analysis and the effectiveness of the proposed UOMS.

Frequency Division Multiplexing-based Power/Signal Synchronous Transmission Strategy for IPOS-DAB DC/DC Converters

Frequency Division Multiplexing-based Power/Signal Synchronous Transmission Strategy for IPOS-DAB DC/DC Converters

DC Power-Line Communication Based on Power/Signal Dual Modulation in Phase Shift Full-Bridge Converters

Simultaneous Power and Data Transmission Using Combined Three Degrees of Freedom Modulation Strategy in DC–DC Converters

Power Conversion and Signal Transmission Integration Method Based on Dual Modulation of DC–DC Converters

A Multiplexing Modulation Strategy Based On Single-Phase Ac/Dc Converter With Optimized E-Capless Function

Power-Estimation-Based Synchronous Rectification Solution for Bidirectional DAB-LLC Converter

Talkative Power Conversion Strategy Based on Direct Sequence Spread Spectrum with Gold Sequence

A Full-Power-Range Optimization Scheme Under Double-Side Asymmetrical Phase-Shift Modulation in DAB-Based Distributed Energy Storage System

Research on Optimum Extended Phase-Shift Control with Minimum Peak-to-peak Current of DAB Converter Applied to Small DC Power Grid

Bidirectional Communication Between Parallel Buck Converters

A Low-Frequency Ripple Suppression Strategy for Multi-Module DAB Fed Single-Phase VSI

Power and Signal Dual Modulation with Info Nature of Power Converters

Multi-Objective Optimization Method Based on Double-Side Asymmetrical Modulation Scheme for DAB-Based DC-DC Converter

A Second Harmonic Suppression Method Based on Differentiated-Capacitance Design for Input-Parallel Output-Series DAB Fed Single-phase VSI

An Optimal Primary-Side Duty Modulation Scheme with Minimum Peak-to-Peak Current Stress for DAB-Based EV Applications

Optimal Modulation Techniques of a DAB Based Isolated Bidirectional Single-stage Single-phase AC-DC Converter

Modulation and Soft-Switching Optimization Control of Multilevel Dual Active Bridge DC-DC Converters

A Unified Optimal Modulation Strategy for DAB Converters to Tradeoff the Backflow Power Reduction and All ZVS in the Full Operating Range

Hybrid control of ISOP-DAB converters based on double-loop decoupling

A Unified Optimal Modulation Strategy for DAB Converters to Trade-off the Backflow Power Reduction and All ZVS in the Full Operating Range