Polymer/Inorganic Aluminum Salt Weak Gel for Reservoir Permeability Control and Oil Displacement at Gudong Oil Fields and Its Preliminary Field Trial Use

Xiong Guo

2002-01-01

Abstract:In water flooding reservoirs at Gudong, Shengli, intra- and interlayer channellings are developed, coning of injected water and polymer happens and blockages are often created in the near-bore zones of polymer injection wells. A weak gel system for reservoir permeability control/oil displacement is prepared from an HPAM (Mitsubishi′s MS3500 with M=1.9×10 7 and HD=26.4%) of 1 000 mg/L, an inorganic aluminum salt as crosslinker of 50-150 mg/L, and a stabilizing additive of 10-15 mg/L in oilfield produced water of TSD=3 900 mg/L. The gelling solutions with Al salt of 50,100,and 150 mg/L (denoted as CDG-50,-100,-150, respectively) have slightly lower viscosity at 60℃ than that of corresponding polymer solution (PS), 41 mPa·s, as prepared and gradually decreased values of viscosity at 60℃ in the course of long term reaction at 60℃ with small differences between themselves, being ca 30 mPa·s after 56 days of reaction. Similar values of resistance factor, RF, (76～94) are observed for newly prepared CDG-50,CDG-100, and PS when flowing through artiticial cores of K g 4.2-4.3 μm 2 at 60℃ and the RF value for PS decreases gradually however the RF values for CDG-50 and for CDG-100, in particular, increase more and more rapidly in the course of reaction (60℃, 0-42 days). The CDG weak gel system is used preliminarily in reservoir permeability control/oil displacement at well group Gudong 7-29-194. Two slugs are injected: 1 000 m 3 of CDG-100 and 1 600 m 3 of CDG-50 and the tentative results are satisfactory: increase in starting water injection pressure from 0.4 to 6.7 MPa, decrease in water absorption rate from 30 to 28 m 3/d·MPa, increase in daily oil production from 6 correlated wells from 29 to 48 tones, and decrease of water cut from 96.1% to 90.1%.