Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

Fabrication of Graphene‐Encapsulated Oxide Nanoparticles: Towards High‐Performance Anode Materials for Lithium Storage

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

Construction of Moo2 Quantum Dot-Graphene and Mos2 Nanoparticle-Graphene Nanoarchitectures Toward Ultrahigh Lithium Storage Capability

Fe3O4 nanoparticle anchored layered graphene films for high performance lithium storage

Graphene bubble film encapsulated Si@C hollow spheres as a durable anode material for lithium storage

Surfactant-assisted Encapsulation of Uniform SnO2nanoparticles in Graphene Layers for High-Performance Li-storage

Fabrication of Graphene Nanoplatelets-Supported Siox-Disordered Carbon Composite and Its Application in Lithium-Ion Batteries

Construction of Zn2GeO4/Graphene Nanostructures with Dually-Protected Functional Nanoframes for Enhanced Lithium-Storage Performances

Encapsulation of Sn@carbon Nanoparticles in Bamboo‐like Hollow Carbon Nanofibers As an Anode Material in Lithium‐Based Batteries

Enhancing lithium storage performance by strongly binding silicon nanoparticles sandwiching between spherical graphene

Micro‐/Mesoporous Zinc–Manganese Oxide/Graphene Hybrids with High Specific Surface Area: A High‐Capacity, Superior‐Rate, and Ultralong‐Life Anode for Lithium Storage

Electrostatic Spray Deposition of Porous Sno2/Graphene Anode Films and Their Enhanced Lithium-Storage Properties

Graphene Anchored with Co(3)o(4) Nanoparticles As Anode of Lithium Ion Batteries with Enhanced Reversible Capacity and Cyclic Performance.

Design of pseudocapacitance and amorphization Co-enhanced Mn3O4/graphene sheets nanocomposites for high-performance lithium storage

Anomalous Interfacial Lithium Storage in Graphene/tio2 for Lithium Ion Batteries.

Synthesis of a zinc ferrite effectively encapsulated by reduced graphene oxide composite anode material for high-rate lithium ion storage

Hierarchically Hollow and Porous NiO/NiCo 2 O 4 Nanoprisms Encapsulated in Graphene Oxide for Lithium Storage

The mechanistic exploration of porous activated graphene sheets-anchored SnO2 nanocrystals for application in high-performance Li-ion battery anodes.

Graphene Caging Silicon Particles for High-Performance Lithium-Ion Batteries.

High‐Performance Li–O2 Batteries Based on All‐Graphene Backbone

Superior Li-ion Storage Performance of Graphene Decorated NiO Nanowalls on Ni As Anode for Lithium Ion Batteries