Abstract:A novel theoretical model capable of quantifying the stress causing transient thermal strain (TTS) in heated concrete has been proposed in this work. It can be used in finite element models or as a direct design equation to help structural designers in assessing the stress developed during heating of concrete members caused by combined actions of mechanical loads, heating fluxes and end restraints. The model classifies heated concrete problems into three categories; concrete members heated to a certain temperature then loaded; concrete members stressed to a certain level and then heated to a certain temperature under load; concrete members heated with fully restrained ends with or without external loading. The new TTS equation has been incorporated in a novel coupled thermo-mechanical finite element model in the framework of ABAQUS. Material models capable of capturing the constitutive behaviour and specifically the degradation of material properties experienced by concrete exposed to elevated temperatures, have been selected from the literature and have been adapted to include TTS and, where absent, temperature dependence. The FE model, along with the developed stress equation, has been validated against experimental results in which samples were tested under various loading configurations and boundary conditions. It has been shown to successfully reproduce the results for all of the studied cases. Furthermore, in exploring these scenarios a number of observations were made. Firstly, it was found that the stress developed under restraint is lower than under applied preload, but that stress relaxation in part due to TTS is higher in preloaded samples. Secondly, the limit of elastic behaviour appears to be reduced in samples subject to free thermal expansion compared to those under restraint. Finally, while free thermal expansion is critical to the overall stress-strain response there is evidence that it varies with the applied stress and significantly increases at high temperatures.

The Temperature Stresses of Euler Beam under Different Deformation States

Analytical solution for fixed-end orthotropic beams subjected to uniform load

Computation of Local Bearing Stress in Web of Beams Supporting Overhead Cranes

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

Elastoplastic Analysis with Fine Beam Model of Vector Form Intrinsic Finite Element

Elasticity Solution of Laminated Beams Subjected to Thermo-Loads

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

Effect analysis of steel-concrete composite beam caused by sudden change of temperature

Elastoplastic Analysis and Practical Calculation of Steel Beam Columns under Fire Condition

The Finite Element Model Study of the Pre-Twisted Euler Beam

Effect of Temperature and Spring-Mass Systems on Modal Properties of Timoshenko Concrete Beam

A Generalised Model for Direct Prediction of Stresses in Concrete at High Temperatures

Shakedown Analysis of Elastic-Plastic Structures Considering the Effect of Temperature on Yield Strength: Theory, Method and Applications

Thermal buckling FEM of large space structures including thin-walled open section beams

Effects of Longitudinally Non-Uniform Temperature Distribution on Steel Beams under Fire Conditions

Theoretical Analysis and Simulation of Thermoelastic Deformation of Bimorph Microbeams

Elastic mechanics solution of thermal expansion of bi-material curved beam and its application to negative thermal expansion metamaterials

Stress–strain constitutive equations of concrete material at elevated temperatures

Analytical Methods for Temperature Field and Temperature Stress of Column Pier under Solar Radiation

Two-dimensional Thermoelasticity Solution for Functionally Graded Thick Beams

SIMPLIFIED CALCULATION OF AXIAL DEFORMATION OF CONCRETE MEMBERS EXPOSED TO HIGH TEMPERATURE