Abstract:A comprehensive numerical analysis is conducted to investigate rarefied hypersonic flows over two-dimensional (2-D) and three-dimensional (3-D) non-rectangular cavities with inclined front or rear walls using the direct simulation Monte Carlo (DSMC) method. The objective is to give a contribution to the understanding of the effects of inclined front or rear walls on flow features and aerodynamic surface quantities. The 3-D or finite-span effects are also analysed in depth. Results show that inclining the front wall of the cavity has a negligible effect on gas flows in the rear part of the cavity, and consequently does not affect surface pressures on and heat fluxes to both the cavity floor and the rear wall. This is because high-speed gases enter the cavity via the top of the rear wall, which is exactly the dominant drive force for gas flows in the rear portion of the cavity. Inclining the front wall does not alter this drive force, so it does not influence gas flows there. However, inclining the rear wall not only strongly influences the flows close to the rear wall, but also has a profound influence on the flows in the front portion of the cavity. Specifically, it can substantially enhance the flow expansion in the front portion of the cavity, make the front vortex shorter and moves the front vortex upward and leftward. The 3-D or finite-span effects play an important role in the flow features and surface quantities of rectangular, inclined-front, and inclined-rear cavities. The finite-span effects exhibit as the 3-D relieving effects, which prevent the external stream from penetrating deeper into the cavity. This consequently lessens the momentum and energy that are transferred into the cavity and brings about a significant decrease in the pressure on and heat flux to the cavity floor. The results in the work can be applied to the accurate prediction of the pressure and heating loads of the thermal-protection tiles of hypersonic vehicles.

Analysis of the Effect of the Modification at the Trailing Edge on Cavity Flow Characteristics

Studies on Flow Characteristics of Cavity by Numerical Simulation and Wind Tunnel Test

Investigation of Spectral Characteristics by Passive Control Methods Past a Supersonic Cavity

Experimental Study of Vortex Shedding Frequency at Trailing Edge of a Cavity-Based Strut

Experimental and Numerical Investigation on the Cavity Regime and Drag Reduction of Ventilated Partial Cavity

Effect of the Gust Wave on the Dynamic Behavior of Cavity Closure and Pressure: A Numerical Study

Effect of Morphed Trailing Edge on the Acoustic and Flow Characteristics of National Advisory Committee for Aeronautics (NACA) 4418 Airfoil

Numerical Analysis of Supersonic Flows over an Aft-Ramped Open-Mode Cavity

Effects of Lateral Space and Angle of Attack on Ventilated Partial Cavity

The Effect Of Pressure Distribution On High Speed Cavitation Flow Inside Throttling Valve

On the effect of velvet structures on trailing edge noise: experimental investigation and theoretical analysis

Boundary layer analysis of ventilated partial cavity for friction drag reduction

Effect of Trailing-Edge Modification of A Mixed-Flow Pump

Experimental Study on the Suppression of Cavity Noise in a Locking-On State by a Slanting Inner Wall

The mechanism and control of an open cavity flow

Numerical Evaluations Of The Effect Of Leading-Edge Protuberances On The Static And Dynamic Stall Characteristics Of An Airfoil

A study of the effect of serration shape and flexibility on trailing edge noise

An Analysis on the Flow Field Structures and the Aerodynamic Noise of Airfoils with Serrated Trailing Edges Based on Embedded Large Eddy Flow Simulations

The Control of Aerodynamic Sound Due to Boundary Layer Pressure Gust Scattering by Trailing Edge Serrations

Numerical analysis of rarefied hypersonic flows over inclined cavities

Effect of trailing edge shape on the separated flow characteristics around an airfoil at low Reynolds number: A numerical study