Abstract:Air traffic has developed rapidly in the last decades. The noise generated from aircraft can impair the health of passengers and airport residents, so it is necessary to reduce aircraft noise and relieve the annoyance due to aircraft noise. As one important component of aircraft wings, the high-lift device is a barrier to the noise reduction of the large commercial civil aircraft in the next stage, especially during the approach and landing phases. When the slat and flap of the high-lift device are both stowed, some gaps and cavities will emerge and radiate strong noise. However, little attention has been paid to these geometric structures on real aircraft. This paper presents an experimental investigation on the far-field aeroacoustic characteristics of the stowed 30P30N high-lift configuration in the cruise condition, namely with slat and flap both stowed absolutely. The experiment of acoustic field measurements with a far-field microphone and acoustic microphone array shows that the gap between the main element and stowed flap on the pressure surface is the main noise source and can radiate tonal noise in the low-frequency range. The flow field measurement aided by a hot-wire anemometer reveals that the frequencies of the intense fluctuations near this gap are close to the tonal frequencies in the far-field noise spectra. Finally, with the applications of a gap cover and tripping device, the tonal noise of the stowed 30P30N high-lift configuration can be obviously suppressed because the feedback loop between the boundary layer instability upstream and the pressure wave from the flap-main element gap has been disturbed.

Cabin Noise Source-Path Identification for AD-200 Ultralight Aircraft

Active Radiation Noise Control of Airplane's Cabin Using Piezoelectric Elements

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

An Investigation of Reverberation Chamber High-Frequency Vibration-Acoustic Problem for an Aircraft Cabin Title

Experimental Study on the Noise Source Identification of a Diesel Engine of Passenger Car

Prediction of aircraft cabin noise by statistical energy analysis

Application of measurement technology of sound intensity in noise source identification of automotive interior noise

The Application of Sound Intensity Method to the Noise Measurement of Electrical Machines with Load

Acoustic Environmental Experiment and Numerical Simulation of Apparatus Cabin of Aircraft in Reverberation Chamber

Application of sound intensity and partial coherence to identify interior noise sources on the high speed train

Subjective Evaluation of the Acoustic Annoyance in a Large Passenger Aircraft Cabin

Simulation and Analysis of the Cabin Typical Structure under Vibro-acoustic Combined Environment

Developments of Aeroacoustic Investigation on High-Lift Device for Large Aircrafts

Acoustical Source Separation and Identification Using Principal Component Analysis and Correlation Analysis

Numerical Analysis and Measurement Techniques for Aircraft Cabin Noise Using JAXA's Jet-FTB "HISHO"

Investigation of aeroacoustic localization technique in lining test section

Acoustic Sensitivity Analysis on Dominant Transmission Paths for Noise Reduction Design of Super-large Crude Carrier

APPLICATION OF SOUND INTENSITY TECHNIQUE IN IDENTIFY THE NOISE SOURCES OF MAGLEV TRAIN

Acoustic Modelling and Analysis of Vehicle Interior Noise Based on Numerical Calculation

Human-induced noise study for cruise cabin: Numerical analysis and experimental validation

Experimental Investigation of the Far-Field Noise Generated from the Cruise Configuration of Aircraft High-Lift Device